2.Removetheboltsthatsecuretheoiltanktothefueltank,and drain all oil from the tank.
3.Remove cock holder, then clean strainer and cock holder in a kerosene solution.
4.Make sure every part is clean and dry, then reassemble oil tank. Fill oil tank with
FUEL AND OIL LINES
■Check the fuel and oil lines regularly for damage and ensure that there are no leaks.
■Replace fuel and oil lines every 2 years to maintain performance.
■When replacing the oil hose perform the following procedure:
1.Replaceoilhosewithmanufacturessuggestedtypehoseor equivalent.
2.If necessary, fill oil tank with
3.Fill fuel tank with 25:1 fuel mix ratio.
4.Operaterammerwith25:1fuelmixtureuntilallairisbledfrom oil injection line.
5.Once it is certain that all air has been purged from the oil injection line, regular unleaded gasoline may be used.
CAUTION:
It is normal for a new
MTR-35HS — MAINTENANCE
CLEANINGTHERAMMER
■If using a high pressure spray washer, be careful not to splash water directly on the air cleaner, carburetor, muffler, fuel and oil tank caps. Excessive amounts of water may cause severe engine damage.
Yearly
■Check the fuel line and the oil line regularly for damage and to ensure that there are no leaks.
■Replace the oil and fuel lines every two years to maintain the performance and flexibility lines.
Long Term Storage
■Drain fuel from fuel tank, fuel line and carburetor.
■Remove spark plug and pour a few drops of motor oil into cylinder. Crank engine 3 to 4 times so that oil reaches all internal parts.
■Clean exterior of rammer with an
■Store unit covered with plastic sheet in moisture free and dust free location out of direct sunlight
PAGE 16 —