Multiquip operation manual MT-85H Troubleshooting Guide

Page 15

MT-85H — TROUBLESHOOTING GUIDE

TABLE 3. ENGINE TROUBLESHOOTING

SYMPTOM

POSSIBLE PROBLEM

SOLUTION

 

 

 

Difficult to start

 

 

 

 

 

 

Ignition plug being bridge?

Check ignition system.

 

 

 

Fuel is available but spark plug

Carbon deposit at ignition?

Clean or replace ignition.

 

 

will not ignite. (Power available at

Short circuit due to defective

Replace insulators.

high tension cable).

insulators?

 

 

 

 

 

 

 

Improper spark gap?

Set spark plug gap to the correct gap.

 

 

 

Fuel is available but spark plug

Short circuit at stop switch?

Check stop switch circuit. Replace stop switch if defective.

will not ignite. (Power NOT

 

 

 

 

available at high tension cable).

Ignition coil defective?

Replace ignition coil.

 

 

 

 

Muffler clogged with carbon

Clean or replace muffler.

 

deposits?

 

 

 

 

Fuel is available and spark plug

Mixed fuel quality is inadequate?

Check fuel to oil mixture.

 

 

ignites (compression normal).

Fuel in use inadequate (water,

Flush fuel sytem and replace with fresh fuel.

 

 

dust)?

 

 

 

 

 

Air Cleaner clogged?

Clean or replace air cleaner.

 

 

 

 

Defective cylinder head gasket?

Tighten cylinder head bolts or replace head gasket.

Fuel is available and spark plug

 

 

Cylinder worn?

Replace cylinder.

ignites (compression low ).

 

 

 

Spark plug loose?

Tighen spark plug.

 

 

 

Operation not satisfactory

 

 

 

 

 

 

Air cleaner clogged?

 

 

 

 

Not enough power available

Air in fuel line?

Bleed (remove air) from fuel line.

 

 

(compression normal, no miss-

Fuel level in carbureator float

 

firing).

Adjust carbureator float

chamber improper?

 

 

 

 

 

 

Carbon deposits in cylinder?

Clean or replace cylinder

 

 

 

 

Ignition coil defective?

Flush fuel sytem and replace with fresh fuel.

Not enough power available

 

 

Ignition plug often shorts?

Replace ignition wires, clean ignition.

(compression normal, miss-

 

 

firing).

Fuel in use inadequate (water,

Flush fuel sytem and replace with fresh fuel.

 

 

dust)?

 

 

 

 

 

Mixed fuel quality is inadequate?

Check fuel to oil mixture.

 

 

 

 

Excessive carbon depostion in

Clean or replace crankcase.

Engine overheats.

combustion chamber?

 

 

 

Exhaust or muffler clogged with

Clean or replace muffler.

 

 

carbon.

 

 

 

 

 

Spark plug heat value incorrect?

Replace spark plug with correct type spark plug.

 

 

 

MT-85H — PARTS & OPERATION MANUAL — REV. #8 (06/26/01) — PAGE 15

Image 15
Contents Tamping Rammer Model MT-85H Page Heres HOW to GET Help Table of Contents UPS Ground Service at no charge for freight Parts Ordering ProceduresRules for Safe Operation Maintenance Safety TransportingEmergencies Operation and Safety Decals Rammer Gearbox and Spring Cylinder General InformationDefinition of Tamping Rammer Construction of Tamping RammerMT-85H Specifications MT-85H Controls and Components Inspection MT-85H OperationRammer Gearbox and Spring Cylinder Oil Bath EngineStopping The Engine Throttle Control LeverMT-85H Maintenance MT-85H Troubleshooting Guide MT-85H Troubleshooting Guide MT-85H Note Items Found In the Items Number Column Explanation of Code in Remarks ColumnMT-85H- Suggested Spare Parts MT-85H Crankcase and Engine Crank Gear MT-85H Guide Cylinder and Foot MT-85H Guide Cylinder and Foot MT-85H Tank and Handle Fuel Tank ASSY.,3L EC-12G Engine Robin Crankcase and CYL. Head Stud EC-12G Engine Robin Crankshaft and Piston Crankshaft and Piston EC-12G Engine Robin Crankshaft and PistonEC-12G Engine Robin Muffler and AIR Cleaner Muffler Compl EC-12G Engine Robin Governor Governor Yoke EC-12G Engine Robin Blower HOUSING/RECOIL STR LABEL, Engine Name EC-12G Engine Robin Electric Device Flywheel Compl EC-12G Engine Robin Carburetor Packing Terms and Conditions of Sale Parts Page WWW multiquip.com