Battery installation, Mounting, Placement tips

Battery installation

•Remove the screws from the battery compartment with a small Phillips screwdriver.

•Set the channel 1 through 5. The switch is located in the battery compartment. Channel 1 is typically selected if only one remote thermo-hygrometer is being used.

•Install 2 "AA" size alkaline batteries (not included) matching the polarities shown in the battery compartment.

•Replace the battery compartment door and secure the screws.

•Secure the remote thermo-hygrometer in the desired location.

Mounting

•The remote thermo-hygrometer can be placed on the flat surface or mounted on the wall in vertical position

•Use the wall mount hardware and screws provided when mounting the remote thermo-hygrometer on the wall

Placement tips:

•The remote thermo-hygrometer should be placed in the area with a free air circulation and sheltered from the direct sunlight and an extreme weather conditions.

•Ideally, place the remote thermo-hygrometer above the natural surfaces (such as a grassy lawn).

•Avoid placing the remote thermo-hygrometer near sources of heat such as chimneys and heating elements.

•Avoid any areas collecting and radiating a heat from the sun, such as metal, brick or concrete structures, paving, patios and decks.

•The international standard for the valid air temperature measurements is 4 feet (1.25meters) above the ground.

Note: To display the readings from the remote thermo- hygrometer you must own the main display unit of the Meade Professional Weather Station TE923W-M, model number TE923W-M. Additionally it will work with all other Meade weather station models.