Wall mount Stand, Apply factory settings

Display panel

Change the brightness of the SoundBar display panel.

1 Press SETUP repeatedly to select DISPLAY on the display panel (see ‘Setup menu

2	options and settings’ on page 18).
2	Press OK.
3	Press the Navigation buttons ( / ) to

select BRIGHT, DIM 1, or DIM 2, and then press OK.

You can reset your SoundBar to the default settings programmed at the factory.

In AUX mode, within three seconds, press TREBLE+, VOL-, and BASS+.

»» When the factory settings restore is complete, the SoundBar automatically switches off and restarts.

stand	nglish
	E

Before you mount your SoundBar to the wall or onto a single stand, read all safety precautions (see ‘Safety’ on page 5).

If you have any query, contact Philips Consumer Care in your country.

Screw length/diameter

Depend on the type of wall mounting this wall mount bracket, make sure that you use screws of a suitable length and diameter.

Note

•• Before wall mount, you can remove the three rubber feet at the bottom of the SoundBar.

•• If you remove the rubber feet, you cannot stick them back on the bottom of the SoundBar.

For information about how to wall your SoundBar, see the wall mount guide.

EN 19