VCS4007 / VCS4017 / VCS4027 / VCS4037 / VCS5007 / VCS5017 / VCS5027 / VCS5037 Assembly
Step 17: Install the LP Cylinder (LP Models Only)
Parts Required:
(1) LP Gas Cylinder (not included)
Note: Check your user’s manual for the cylinder filling requirements, how to attach the regulator and how to test for leaks before you try lighting the grill.
Caution: Make sure the hose is not touching any hot surfaces.
Note: For Models VCS5007, VCS5017, VCS5027 & VCS5037, refer to Tank
Fig. 17a |
Place the LP Cylinder into the hole in the bottom panel. Next secure it from moving by lifting the Cylinder retainer wire and latching the bent edge over the lip of the Cylinder. The final step is to connect the Regulator to the Cylinder.
Caution: Do not turn on the grill until after performing a leak check at all connection points and fittings. Use a spray solution of 50% dish soap and 50% water onto all connection points and fittings. Formation of bubbles indicates air leaks.
Note: Ensure all plastic coatings have been removed from all stainless steel parts before using the grill.
Fig. 17b |
CFM Corporation
410 Admiral Boulevard
Mississauga, Ontario L5T 2N6 Canada
(800)
www.cfmcorp.com
Service Note: If you are experiencing difficulties or are dissatisfied with your purchase, please contact CFM at the telephone number listed above prior to returning your grill to the store.
Page 8