Leak Testing
Although all gas connections on the grill are leak tested at the factory prior to shipment, a complete gas tightness check must be performed at the installation due to possible mishandling in shipment or excessive pressure unknowingly being applied to the unit. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected.
1
•Do not smoke while leak testing.
•Extinguish all flames.
•Never leak test with an open flame
CAUTION
Before placing into operation, always check for gas leaks with a soapy water solution. DO NOT USE AN OPEN FLAME TO CHECK FOR LEAKS.
2
OFF
5 | 6 |
Bubbling bubbles in the soap solution indicates that a | Stop a leak by tightening the loose joint or by |
leak is present. | replacing the faulty part with a replacement part |
| recommended by the manufacturer. |
7 | 1 |
8 |
2
Make a soap solution of one part liquid detergent and | Check that all control knobs are in the “OFF” position. | |||||
one part water. You will need a spray bottle, brush or |
|
|
| |||
|
| towel to apply the solution to the fittings. |
|
|
| |
Note: For LP/Propane units, check with a full cylinder. |
|
|
| |||
3 |
| 4 | ||||
| ||||||
| ||||||
|
|
|
|
|
|
|
Apply the soap solution to fittings. | Turn cylinder valve knob counter clockwise one |
| turn to open. |
Do not attempt to repair the cylinder valve if it should | If you are unable to stop a leak, shut off the gas |
become damaged. The cylinder must be replaced. | at the cylinder valve. Remove the cylinder from the grill. |
9
Call an authorized gas
appliance service technician or LP/Propane gas dealer.
Do not use the grill until
the leak is corrected.
OFF
2
1
After checking for leaks, push in and turn any control knob to release the pressure in the hose and manifold.
Turn off the control knob.
28 | 29 |