Viking VGBQ300-2RT1, VGIQ300-2RT1, VGBQ300-2RE1 manual Clearance Dimensions & Hood Swing

OUTDOOR—C OOKING

30”W. Ultra -Pre mium T-Series/E -Se ries Gas Grill

Dimensions & Specifications

CLEARANCE DIMENSIONS & HOOD SWING

2
2-
	1
(		5
			/
5				1
	8.				6
		3				”
			c
				m)

		1
		6-
	(			5
						/
		4					8
			2.					”
				2
						c
							m)
				1
				0-
			(				1
								/
				2					4
					6.					”
							0
								c
									m)
(		6
			”
1
	5.
		2
				c
					m)

2
9-
(			1
				/
7					2
	4					”					8
		.						(
		9										”
				c				2
					m)					0.
											3
												c
													m)
													*
							5-
								3
								/
							(		8
											”
							1
							3.
								7
									c
											m)

”

m

in

.

o

n

-

3

o

n

)

t

m

b

le

.6

c

st

a

(7

bu

e

m

c

co

rfa

s

u

.

in

m

”

o

2

4

)

t

c

m

le

.0

b

(6

1

ta

6

”

u

s

/1

b

-9

o

m

ce

)

a

1

c

rf

3

c

m

s

u

2

(80

.

”

-

3

/4

2

)

3

.2

c

m

3

(8

Minimum clearances from adjacent combustible construction

1.Maintain a min. of 6” (15.2 cm) from the sides, or a min. of 8” (20.3 cm) from the right side if there is a rotisserie motor, and a min. of

24” (61.0 cm) from the back above the cooking surface to adjacent vertical combustible construction. Do not place grill under unprotected combustible construction.

2.Maintain a min. of 3” (7.6 cm) clearance from the back of the grill with a canopy and a min. of 6”

(15.2 cm) from the back of the grill without a canopy to non-combustible construction to allow the lid to open fully and for proper ventilation. (The grill exhausts combustion products and cooking greases to the back.)

Never place the grill where the exhaust is directed at a window, less than 2’ (61.0 cm) to combustible material, or any surface that is difficult to clean. Allow at least 6” side clearance to non-combustible construction above the cooking surface for counter space. If using the rotisserie option, the space is essential for motor and skewer clearance. The grill can be placed directly adjacent to combustible and/or non-combustible construction below the cooking surface.

3.When determining a suitable location for the grill, take into account exposure to wind, proximity to traffic paths, and keeping gas supply lines as short as possible. Place the grill only in a well-ventilated area. Never place the

grill in a building, garage, breezeway, shed, or other fully enclosed areas. During heavy use, the grill will produce a lot of smoke; ensure you have adequate room for smoke to dissipate.

4.If using a rear wall, place the electrical service on the right-hand side for the rotisserie motor.

IMPORTANT:Gas fittings, regulator, and installer-supplied shut-off valve must be easily accessible.

PLANNING	AND	DESIGN	GUIDE	RE LE A S E D 8/ 5 /0 8
VI KIN GRA NGE	.COM	• 1 -888	-V IK ING 1	© 2 0 0 8 V R C — INFORMATION SUBJECT TO CHANGE