Meco 7110.7.641 manual Before Using Your GAS Grill, Installation Codes

Page 12

3)Lift and swing LP Cylinder Retainer Clip to outside of grill. Set LP cylinder in the large hole inside the Bottom Shelf. Rotate the LP cylinder toward the front of grill so regulator hose may connect. (FIG. 11A)

Rotate

Cylinder

Cylinder

Retainer Clip

FIG. 11A

4)Cut the tie clamp securing the regulator and Hose to the burner tube.

Cut regulator Hose

To avoid pinching in next step, keep fingers and hands near corners of Cylinder Retainer Clip when swinging Clip over cylinder.

6)Swing the Cylinder Retainer Clip over round shoulder of the LP cylinder. Exert pressure at ends of clip until it stops at the cylinder carry handle.

Cylinder

Carry Handle

Cylinder

Retainer Clip

FIG. 11D

Disconnecting LP gas cylinder:

1)Turn all control knobs to the “off” position and turn the handle on the LP gas cylinder clockwise until it stops.

2)Turn coupling nut on regulator counter- clockwise until regulator is released from the threaded LP cylinder gas nozzle.

3)Replace the protective cap over LP cylinder gas nozzle.

FIG. 11B

Tie Clamp

BEFORE USING YOUR GAS GRILL

5)Remove the protective cap from the LP cylinder nozzle. (Save cap for re-capping.) Make sure all control Knobs are turned “OFF”. Hold Regulator in a straight line with LP cylinder valve so the connection does not cross thread. Insert Regulator Nipple into the LP cylinder valve. (Fig. 11C) Hand tighten coupling nut in clockwise direction. Do not use tools.

Hand tighten coupling

nut in clockwise direction

Remove

Protective Cap

FIG. 11C

INSTALLATION CODES

To reduce the risk of serious bodily injury or death:

·This installation must conform with local codes or, in the absence of local codes, with either the National Fuel Gas Code, ANSI Z223.1/NFPA 54 Natural Gas and Propane Installation Code, CSA B149.1, or Propane Storage and Handling Code, B149.2 or the Standard for Recreational Vehicles, ANSI A 119.2/NFPA 1192 and CSA Z240 RV Series, recreational Vehicle Code, as applicable.

·If an external electrical source is utilized, the outdoor cooking appliance, when installed, must be electrically grounded in accordance with local codes or, in the absence of local codes, with the National Electrical Codes, ANSI/NFPA 70, or the Canadian Electrical Code CSA C22.1.

·Keep any electrical supply cord away from any heated surfaces.

12

Image 12
Contents LP Gas Grill Assembly and Use Manual Contents Assembly InstructionsParts Illustrations Page LP Cylinder Clip Axle PIN Assemble Hood/Bowl to Cart 23 M4 Wingnut Left Side Right Side Fabric Panel Right Side CONNECTING/DISCONNECTING the GAS Using GASOperating Your LP GAS Grill LP GAS CylinderBefore Using Your GAS Grill Installation CodesSelecting a Location Performing a Leak TestLighting the Grill Using the Ignitor Manual Lighting the Grill Check Your FlameGrill Cooking Warming Rack Roasting CookingOperating the GAS Grill END of Cooking SessionCare and Maintenance Cleaning the GrillStorage Gas Leaks and Fire Emergencies Troubleshooting Cont’d Important Notice Meco Corporation Limited Warranty Aussie