Lighting the Grill Using the Ignitor

To reduce the risk of serious bodily injury or death:

·Open Hood before lighting the grill to prevent an explosion from any gas accumulation.

·If lighting attempts fail, or the burners go out during operation, turn all control knobs “Off” to dissipate any accumulation of gas. Accidental ignition could occur. Wait five minutes before repeating lighting procedure.

·Light both left and right sides of burner to prevent gas from accumulating.

LIGHTING THE GRILL USING THE IGNITOR

1.	Open the Hood.
2.	Important: Make sure all control knobs are turned
	“Off”. (FIG. 13A)
3.	Turn the LP Gas Cylinder valve open counter
	clockwise until it stops. (FIG. 13B)
4.	Push the left control knob in and turn counter
	clockwise to the High flame position. (FIG. 13C & 13D)
5.	Pause 4 seconds and push the ignitor button in
	several times to light the burner. Listen for the spark
	ignition and look to make sure the burner is lit. If no
	spark, see (FIG. 13E) and Troubleshooting Section.
6.	From the “Off” position, push right control knob in
	and turn counterclockwise to the High position. Your
	grill has a crossover ignition system that allows the
	burner to light each side successively. Make sure the
	right side of burner is lit.
7.	If either side of burner fails to light, repeat Step 4.
	If a burner goes out during operation, turn all knobs to
	the “Off” position and close the LP cylinder valve to
	dissipate any accumulated gas. Open hood and wait
	five minutes before attempting to relight the grill.
	If any or all burners fail to light after three or four
	attempts following Steps 4-6, turn all knobs to the
	“Off” position and close the LP gas cylinder valve to
	dissipate any accumulated gas. Wait five minutes; then
	repeat the lighting procedures. NOTE: If the burner
	still fails to light, refer to the Troubleshooting Section.
	The burner can also be lit manually, see Manual

FIG. 13B

Right Control Knob

Left Control Knob

Ignitor Button

FIG. 13C

Control Knob

in HIGH position

FIG.13D

Lighting of the Grill.

8. After ignition, turn the control knobs to “High” for 3-5

minutes and close the Hood to preheat the grill.

Preheat the grill before every cooking session.

Gas Collector

Tab

Gas Collector

Box

Electrode

3/16” GAP

Control Knob

in OFF

position

FIG.13A

If no spark, pinch together or open Gas Collector Tab to adjust 3/16” gap between electrode tip and edge of Gas Collector Tab.