Digital TunerMaintenance
2Press PROGRAM for more than
2 seconds to activate programming.
➜Display: 
appears. Stations available are programmed in order of waveband reception strength: FM, followed by AM.The last preset automatically stored will then be played.
Manual programming
| PLAYBACK |
|
| |
|
|
| ||
MP3 |
|
|
|
|
FM/AM |
|
|
|
|
| o |
|
| S |
| stere | PRESET/ALBUM | SEARCH | |
CD MODE PROGRAM |
| |||
|
| |||
|
|
| ||
1Tune to your desired station (see Tuning to stations).
2Press PROGRAM to activate programming.
➜Display: program and a preset number flashes.
3Press PRESET / ALBUM - or + once or more to allocate a number from 1 to 30 to this station.
4Press PROGRAM again to confirm.
➜Display: program disappears, and shows the preset number, waveband and the frequency.
5Repeat the above four steps to store other stations.
Maintenance
•The lens of the CD player should never be touched!
•Sudden changes in the surrounding temperature can cause condensation to form and the lens of your CD player to cloud over. Playing a CD is then not possible. Do not attempt to clean the lens but leave the set in a warm environment until the moisture evaporates.
•Always shut the CD door to keep the CD compartment
•To take a CD out of its box, press the center spindle while lifting the CD. Always pick up the CD by the edge and replace the CD back in its box after use to avoid scratching and dust.
•To clean the CD, wipe in a straight line from the center towards the edge using a soft,
•Never write on a CD or attach any stickers to it.
•Don’t expose the set, batteries or CDs to humidity, rain, sand or excessive heat.
•Clean the set with a dry cloth. Don’t use any cleaning agents containing alcohol, ammonia, benzene or abrasives as these may harm the set.
English
13