Troubleshooting
If a fault occurs, first check the points listed below before taking the set for repair. Do not open the set as there is a risk of electric shock.
If you are unable to remedy a problem by following these hints, consult your dealer or service center.
WARNING: Under no circumstances should you try to repair the set yourself, as this will invalidate the warranty.
Problem | Solution |
|
|
No sound/power | – Volume not adjusted. Adjust the VOLUME. |
| – Power cord not securely connected. |
| Connect AC power cord properly. |
| – Batteries dead /incorrectly inserted. |
| Insert (fresh) batteries correctly. |
|
|
Display does not function | – Electrostatic discharge. |
properly/ No reaction to | Switch off and unplug the set. |
operation of any of the | Reconnect after a few seconds. |
controls |
|
|
|
INSERT CD or CHECK DISC | – No CD inserted, insert a CD. |
indication | – CD badly scratched or dirty. |
| Replace/ clean CD (see Maintenance). |
| – Laser lens steamed up. Wait until lens has cleared. |
| – |
| Use a finalized |
|
|
CD playback does not work | – CD badly scratched/ dirty. |
| Replace/ clean CD (see Maintenance). |
| – Laser lens steamed up. |
| Wait until lens has acclimatized. |
|
|
The CD skips tracks | – Disc damaged or dirty. Replace or clean disc. |
| – SHUFFLE or a program is active. |
| Quit SHUFFLE / program mode(s). |
|
|
English
19