Magma A10-1225 owner manual Maintenance, Using Grill with ON-BOARD LPG Propane Systems

MAINTENANCE

About Stainless Steel - Stainless steel exposed to prolonged periods of high heat will change color and texture. Magma grills require no preheating. Not preheating will keep your grill cooler and greatly extend the life and beauty of your grill. Texture and color change is normal on interior components and will not affect the product’s operation or performance.

Exterior Stainless Steel Components - Cleaning the exterior surface after every use will help prevent discoloration. Use soapy water with a soft cloth or sponge. Rinse thoroughly with fresh water and dry. We recommend covering the grill between uses. Optional covers are available from Magma retailers or direct from Magma. CAUTION: ABRASIVE PADS OR CLEANERS WILL DAMAGE THE FINISH.

Interior Components - Remove heavy residue from grill and empty grease tray between each use. We recommend complete disassembly and cleaning at least once a year depending on amount of use (see page 5) and always prior to long term storage. For burnt-on residue we recommend Easy-Off brand Oven & Grill Cleaner. If cleaner is used on liner or lid, complete disassembly is recommended to remove any cleaner residue left between components. Wash all components with soapy water after using cleaner. CAUTION: AVOID CONTACT OF IGNITER AND ELECTRODE WIRE AND WIRE CONNECTORS WITH OVEN CLEANER.

Grill Grates - Clean with brass wire brush while grill is warm. Use Oven & Grill cleaner for burnt-on residue. Wash with soapy water and dry prior to storage.

Ceramic Electrode - Located just beside the burner, it should be kept clean of grease and debris. Be careful not to damage the ceramic insulation or bend the wire. See page 5 for electrode spark adjustment.

Control Valve - All valves are set and tested at our factory. Do not attempt to adjust or disassemble the valve in any way. Call Magma if you suspect it is not adjusted properly. Clean valve with a cloth and remove any debris obstructing the gas outlet orifice using a pin or needle. Repair/Replacement Parts - See Magma’s Website for a complete list of Repair or Replacement Parts. www.MagmaProducts.com

USING GRILL WITH ON-BOARD LPG (PROPANE) SYSTEMS

•Magma On-Board LPG (Propane) Valves and Hose Kits allow Magma Grills to be installed within a boats existing on-board, pre-regulated low pressure LPG (Propane) system.

•Use only Magma Type 3 Low Pressure LPG (Propane) Valves. See our Valve Application Guide at www. MagmaProducts.com for correct valve.

•In North America use Magma A10-225 LPG 10' Hose Kit in conjunction with Type 3 Valve. Outside North America check your local dealer for proper hose and fittings.

•A primary shutoff valve (supplied with A10-225 hose kit) must be used with this control valve at point of connection into your system. This allows shut off of gas supply to hose leading to grill.

Gourmet	Gourmet	Type 3
	Gas Grill
Gas Grill		Valve
		Align valve stem key
		to valve chamber
		lock detent and rotate

	Gourmet
Typical Marine &	Gas Grill	Type 3
R.V. Application		Valve
Cylinder Valve
Gauge	Solenoid

Shut off		To other LPG
Gas Regulator	valve	appliance
Propane (LPG)	A10-225	or use cap
	Hose Kit

6