21 | STEP 13a. |
20 | Insert temperature gauge (20) stem |
| through hole in grill lid. Secure with |
| wing nut (K). |
STEP 13b.
Insert alignment pins on back of logo plate (21) through two holes above temperature gauge (20).
LAttach using lock washer (L) and hex nut (J) as shown.
4
E
2
A
Carefully reposition grill as shown.
STEP 7.
Note: Do not over tighten. Air dampers should move freely.
Attach air damper (4) to body (2) using phillips head screw (A) and lock nut (E) as shown.
Repeat step on opposite side for remaining air damper.
J
K
STEP 14.
Attach smoke stack (19) to grill using phillips head screws (A) as shown.
19
A
17
A
18 | STEP 8. |
Note: Position brackets so sharper |
angled ends are used to connect to leg bracket.
Attach side shelf support brackets
(17)to side shelf (18) using phillips head screws (A).
Do not fully tighten at this time.
11
8