ASSEMBLY INSTRUCTIONS
GRILL OPERATION CAUTIONS
B 
2
Before assembly read instructions carefully.
Tools needed for assembly:
Adjustable Wrench
Phillips Head Screwdriver
Assemble grill on a clean, flat surface.
• Avoid bumping or impacting grill. |
• Keep your hands, hair and face away from burning charcoal. |
• This grill has an open flame. Be careful of loose hair and clothing during operation. They may catch fire. |
• Use protective gloves when handling this grill or working with fire. Use protective gloves or long, sturdy fireplace |
tools when adding wood or charcoal. |
• Do not allow anyone to conduct activities around this grill during or following its use until the unit has cooled. This |
grill is HOT during operation and remains HOT for a period of time following its use. |
STEP 1.
Align ash can spacer ring (7) with holes in kettle base (2). Insert phillips head screw (B) through kettle base (2) into ash can spacer ring (7) as shown. Secure with hex lock nut (C).
7
C
• Fatty foods like hamburgers can have excess grease that can cause flare ups. When cooking fatty foods, use |
caution when opening lid and during cooking to avoid being burned. |
• Be careful when removing food from grill. All surfaces are HOT and may cause burns. Use protective gloves or |
long, sturdy cooking tools. |
• Never use glass, plastic or ceramic cookware on this grill. |
• The use of alcohol, prescription or |
safely operate this grill. |
• Grill lid and base are HOT while in use and during cooling process. |
• Do not remove ash can while ashes and charcoal are HOT. |
• Air dampers are HOT while the grill is in use and during cooling; wear protective gloves when adjusting. |
Front of kettle base has two holes for base handle
IA
G 
D
4 2
When all four legs are attached, two long legs will be in front with two short legs in rear.
Assistance may be required for this step.
Do not tighten screws all the way. Legs may need to be adjusted when storage shelf is attached in STEP 3.
STEP 2.
Place heat insulation washers (I) on long legs (4) as shown. Align holes in long legs with holes in kettle base (2). Insert phillips head screws (A) through holes on legs. Secure with aluminum flat washers (G) and serrated flange nuts (D).
Repeat step with short legs on rear side of kettle base.
• Never overfill charcoal grate. This can cause serious injury as well as damage the unit. |
• Only use charcoal lighting fluid, never use gasoline, alcohol or other highly volatile fluids to ignite the charcoal. |
These fluids can explode causing injury or death. |
REMINDER: NEVER OPERATE THIS GRILL UNDER ANY OVERHEAD CONSTRUCTION. MAINTAIN A MINIMUM DISTANCE OF 10 FT (3M) FROM OVERHEAD CONSTRUCTION, WALLS OR RAILS. SEE DIAGRAM BELOW.
Overhead | 10 ft (3m) | |
Construction | ||
| ||
| Rails | |
Wall | 10 ft (3m) | |
|
5 | 10 |
|
|