Char-Broil 463250308 manual Side Burner Assembly, Burner Tube, Valve

4	Side Burner Assembly
	Insert the side burner valve into the side burner and secture it to

the bracket using two #5-40x1/5”screws shown A.

Make sure burner tube aligns correctly onto side burner valve underneath left shelf shown B.

Insert back of side burner through left shelf cut-out shown C, reverse 180° after go through the cut-out and make center stud on bottom rear of burner fits into center hole in burner pan on left shelf.

Secure burner to pan using two #10-24x3/8"screws and 5mm silicon washer and #10 lock washers shown D.

Attach side burner igniter wire from igniter module to electrode tip underneath left shelf shown E.

C

This surface turn over 180° and insert into cut-out then turn back when locating onto the the bracket.

D

5mm Silicon Washer

#10 Lock Washer

#10-24x3/8” Screw

#10 Lock Washer 5mm Silicon washer #10-24x3/8” Screw #5-40x1/5” Screw

A

Burner Tube	side burner
	Valve

#5-40x1/5” Screw

B

Correct Alignment

Incorrect Alignment

E

Electrode

Ignition Wire

18 • 463250308