Char-Broil 463244012 manual Holes on fascia to Attach bezel

		Insert flange on left side shelf into side shelf brackets on side of firebox.
7				7mm flat washers, 1/4” nuts, shown A.
		Attach left side shelf using four 1/4-20x3/4”screws, 7mm lock washers,
		Attach rear of shelf using one 1/4-20x1½”screw, 7mm lock washer, and 7mm flat washer in lower hole, shown B.
		Attach front of shelf and fascia using one #8x3/8” self-tapping screw and large flat washer, shown C.
		Fully tighten lower screws on upper back panel.
	A
			B

1/4-20x3/4” screw

7mm flat washer

1/4”nut

7mm lock washer

1/4-20x1½”	7mm lock	7mm flat	Flange
screw	washer	washer
			into
			Brackets

Left sideburner shelf

C

Bracket

#8x3/8” self-tapping screw

Fascia, left sideburner shelf

large flat washer

8

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right

holes on fascia to Install bezel with “OFF” at top. attach valve bracket

Screws and Washers removed from valve bracket

Sideburner fascia

Sideburner valve bracket

Valve stem

Note: Use upper and lower

holes on fascia to

attach bezel

Control knob #8-32x3/8” screw

4mm lock washer

Control knob bezel

20