Char-Broil 463244012 manual Self-tapping screw

Page 22

11

Insert front brace under control panel and between cart side panels. Make sure door hinge pins are on the top side and facing the front. Secure using two 1/4-20x1½”screws, 7mm lock washers, and 7mm flat washers on each side.

NOTE: MAKE SURE THAT THE FRONT BRACE IS MOUNTED IN THE MOST DOWNWARD POSITION WHEN ASSEMBLED TO CART.

Door

Hinge Pin

7mm flat	7mm lock	1/4-20x1½”
washer	washer	screw
Front brace

12

Inside of cart, insert left and right grease tray rails into slots beneath grease tray opening in upper back panel, shown A. Attach right and left rails under front brace with two #8x3/8” self-tapping screws, shown B.

Note: some parts omitted for clarity of illustration

A

Cart lower back panel

Right rail

Left rail

B

Right rail

Left rail

#8x3/8”

self-tapping screw

22

Image 22

Contents Product Guide Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes Temperature Convective Grills onlyFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillLP Cylinder Filling USE and CareLP Liquefied Petroleum Gas UL listed Overfill ProtectionUseDo not household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF SDo not lean over grill while lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting Open lid during lightingSideburner Match Lighting General Grill CleaningSideburner Ignitor Lighting Burner Flame CheckVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderLimited Warranty Items Manufacturer will not PAY forParts List Key Qty DescriptionParts Diagram Non-lock caster AssemblyRear 7mm flat washers on each side Upper back panel Holes on fascia to Attach bezel Fully tighten lower screws on upper back panelSideburner burner Wing nut Self-tapping screw Wire Flame tamers Tank is attached. Failure to install cylinder Grease trayAA Battery Electronic Ignition Cap Troubleshooting Emergencies Possible Cause Prevention/SolutionAUTO-CLEAN Troubleshooting Electronic Ignition SectionPage Warranty Registration Department Box Columbus, GA