Char-Broil 463666510 manual Qty

Page 18

3

Attach control panel/ HVR assembly to firebox with two #10-24x1/2” machine screws, 7x15 fiber washers, and #10-24 flange nuts (A). Place heat shield onto burner venturi tubes, then insert burner/ heat shield through venturi holes on firebox. Make sure ignitor wire go through the hole on heat shield and firebox as shown (B). Make sure valve and venturi tube align. Attach venturi clips. Attach ignitor wire to ignitor (C).

A

Valve

Venturi tube

C

	#10-24x1/2”	Ignitor	Venturi clip	Ignitor wire
	Machine Screw
		Control Panel
	Qty. 2			Heat Shield

7x15 Fiber Washer

Qty. 2

#10-24 Flange Nut	Burner	Ignitor
Qty. 2	Assembly	wire

HVR Assembly

Firebox

Venturi clip

Qty. 2

Turn cart upright. Place cart in the upright position. Place

4 firebox assembly onto cart, making sure that regulator hose hangs inside cart and control panel overlaps front panel. Secure firebox to cart using four #10-24x1-1/4’’ carriage bolts, 7x15 fiber washers and #10-24 wing nuts.

#10-24x1-1/4’’ Carriage Bolt Qty.4

7x15 Fiber Washer

Qty. 4

Firebox

assembly

Control

panel

Front panel

#10-24 Wing Nut

Qty.4

18

Image 18

Contents Estimated assembly time 45 minutes Date PurchasedTable of Contents This Grill is for Outdoor USE onlyInstallation Safety Precautions California PropositionLava Rock / Briquettes TemperatureFirst Time Use Pre-Heating Your GrillIndirect Cooking Food SafetyDirect Cooking Rotisserie CookingUsda Recommended Safe Minimum Internal Temperatures Routine Care Why Clean?General Cleaning Storing Your GrillUSE and Care LP Liquefied Petroleum GasLP Cylinder Filling For your safety UseDo not household cleaning agents. Damage to gasLP Cylinder Leak Test Leak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Safety Tips For Safe Use Of Your Grill And To Avoid Serious InjuryIgnitor Lighting Turn controls and gas source or tank OFF when notGeneral Grill Cleaning UseCleaning the Burner Assembly Storing Your GrillTurn gas OFF at control knobs and LP cylinder Limited Warranty All Parts Year from date of purchaseParts List Key Qty DescriptionParts Diagram Assembly Align holesQty Push Fastener Qty Qty Qty.2 ’’-20 Flange Nut Lid assembly ’’-20x2’’ Carriage Bolt Qty.1 Not included Troubleshooting Emergencies Possible Cause Prevention/SolutionPiezo PUSH-BUTTON and Rotary Page Warranty Registration Department Box Columbus, GA