Char-Broil 463210511 manual Qty #10-24x1/2 Machine Screw

Page 19

5

Stand cart upright.

Attach tank heat shield to cart back brace with #10-24x1/2" screws.

Tank Heat Shield

Qty: 3

#10-24x1/2"

Machine Screw

6

Place grease tray to the cart assembly as shown.

Insert tank retainer to the holes from the bottom shelf. Attach with a hitch pin.

Grease Tray

Tank Retainer,Wire Form

19

Image 19

Contents Date Purchased Estimated assembly time 35-40 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsPre-Heating Your Grill TemperatureFirst Time Use Lava Rock / BriquettesRotisserie Cooking Food SafetyDirect Cooking Indirect CookingUsda Recommended Safe Minimum Internal Temperatures Storing Your Grill Why Clean?General Cleaning Routine CareLP Liquefied Petroleum Gas USE and CareLP Cylinder Filling Do not use household cleaning agents. Damage to gas For your safetyLP Cylinder Leak Test Connection, do not use this regulator Leak Testing Valves, Hose and RegulatorTurn all grill control knobs to OFF Open lid during lighting For Safe Use of Your Grill and to Avoid Serious InjuryIgnitor Lighting SDo not lean over grill while lightingBurner Flame Check General Grill CleaningSideburner Ignitor Lighting Sideburner Match LightingVery Important Burner tubes must reengage valve Cleaning the Burner AssemblyStoring Your Grill Turn gas OFF at control knobs and LP cylinderAll Parts Year from date of purchase Limited WarrantyFirebox Parts ListParts Diagram 7mm Lock Washer on each AssemblyFront panel UpperQty #10-24x1/2 Machine Screw Qty 20x1/2 Machine Screw Page Qty 20x1/2 #10-24x1/2 #8-32x3/8 Machine Screw #10-24 Hex Nut Tent Heat Page Hose Regulator LP Tank Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Page Warranty Registration Department Box Columbus, GA