Fisher & Paykel BGB36, BGB48 LPG Cylinder Restraint for BUILT-IN Installation, Max

Page 18

INSTALLATION

GAS HOOK-UP

LPG CYLINDER RESTRAINT FOR BUILT-IN INSTALLATION

If the grill is to be installed in a Built-in application, then the grill must be installed in accordance with the Built–in installation guidelines.

If you intend to operate your Built-in grill on LPG gas utilizing a minimum 9 kg cylinder, then the Built-in LPG cyl- inder restraint must be installed prior to initial use of the grill. If you do not have one please contact DCS by Fisher & Paykel for information on obtaining one. See section ‘Service’ for contact details.

The following steps will illustrate how to properly locate and install the LPG cylinder restraint within the Built-in enclosure.

NOTE:

The grill comes with the LPG Regulator/Hose assembly installed at the factory. The assembly, along with the entire grill system, is leak tested.

Do not remove the Regulator/Hose assembly from the grill during installation.

The maximum distance from the centre of the manifold cut out to the centre of the cylinder restraint is 457 mm.

457mm

max.

Centre of Cylinder Restraint must be placed within this area to avoid causing stress on the LPG regulator hose connection.

Centre of manifold cut out projected to floor of the island.

FIG. 13

16

Image 18

Contents User guide Page Message to OUR Customers Please Retain this Manual for Future ReferenceTable of Contents Safety Practices & Precautions Important Safety NoticeSafety Practices & Precautions Grill Placement Flame BurnerSafety Practices & Precautions Grill Models BGB36-BQARInstallation Locating GRILL/BUILT-IN ClearancesLocation Installation Clearances to Non-Combustible Construction Clearances to Non-Combustible ConstructionClearances to Combustible Construction GeneralInsulated Jacket BUILT-IN Construction Details GAS HOOK-UP GAS RequirementsChecking the GAS Pressure Connection with rigid pipingLPG GAS Hook UP LPG Cylinder RequirementsLPG Cylinder Restraint for BUILT-IN Installation MaxStep Leak Testing -- Procedure for a Qualified GAS Fitter Before TestingTo Test LOW Flame Setting Adjustment Burner AdjustmentGrill Burner AIR Adjustment Grill Burner Flame HeightRadiant Assembly Installing the Grease ShieldsRadiant Assembly Installation Griddle Plate Griddle plate to be fitted to centre burner positions onlyInstaller Checklist These InstructionsTag location Model # and Serial # Using the Grill Lighting InstructionsTo Light Side Burners 48BQR Models only DIRECT/INDIRECT Cooking Notes GrillingGrill BurnerGrilling Hints DUAL-SIDED GratesShaped Grate Radius Grate Using the Rotisserie RODWorking Area PreparationRecommended Meat PreparationTo Light the Rotisserie Burner Before Cooking Manual LightingCooking on Rotisserie Care and Maintenance General AdviceRecommended Maintenance Schedule Leak Testing Procedure for the User Battery Replacement Regulator and Hose ReplacementGrill Grates Ceramic Rods Heat ShieldsGrease Tray Drip PANCare and Maintenance To Remove the Grill Burners for Cleaning Stainless SteelSide Burner Ignitors Grill Burner Cleaning Injector CleaningTo Replace the Grill Burners After Cleaning Side Burner Grates BGB48 BQR Model Side Burners BGB48 BQR ModelGrill WON’T Light When the Ignition Button is Pushed TroubleshootingBefore Calling for Service LOW Heat with Knob in HI/SEAR PositionService Write to USPage Warranty Page NZ AU