Power Module, Adapter Holders & Duck, Security

ELECTRICAL

• Avoid sparks. Avoid arcing. Always turn OFF the power
	to the cart before plugging IN or OUT!
•	Be sure each laptop computer is turned OFF before
	plugging into the cart.
•	For Safety Purposes, make sure all electrical components do

Cable Management Instructions

CableWand	2	3	7
CableWand

MOBILITY CART

TX323LL/A

	not exceed the the maximum load rating of 12 amps.
•	Risk of electrical shock. Do not plug the power cord into
	another extension cord or relocatable power tap.
•	The Power Bars inside the laptop cart are only for charging

Remove “Duck Head” & wind cable Stretch Mag-Safe cable from front of cart to back, as shown

Retrieve the “Cable Wand” from the rear	Load the Mag-Safe
cable closet, tucked on the right side	connector as shown
behind the door

One Power Cord Exits the cart & plugs into the wall outlet

Ventilation Channels allow maximum air flow in the cart

laptop computers. Any other use may cause an overload for

the Power Management System, causing the “Brain” to

shutdown, resulting in the LED lights flashing on and off. To

reset the Brain, turn off the main power switch, unplug the

non-laptop computer, then turn the main switch back on.

4	5	6	Hang the Mag-Safe cable in the hook directly over the
4	5	6	Slot, making sure the Clear Cable Trap is in the left
			position. This leaves the hook accessible while cable
			managing the cart. (See Clear Cable Trap description
			below) Place the computer in the slot, and attach the
			Mag-Safe Connector to the computer.

Power Module

keeps the constant flow of power from a single wall outlet charging batteries where needed.

• Do not unplug this product from the outlet when your hands

are wet.

• Do not move the cart by pulling the power cord.

• Do not plug the unit in if the switch, receptacle(s) or power

cord has been damaged.

• Contact Bretford or a qualified electrician before attempting to

make any type of electrical repair or parts replacement.

• Before moving this cart from one room to the next, wrap the

power cord around the cord winder located on the side of the

rt. ca

CAUTION

• Ventilation is critical for laptop computer carts to operate

correctly, providing the appropriate airflow so that heat-

buildup is minimized during the battery-charging process, with

the computers turned OFF. Be sure each laptop computer is

turned OFF before plugging into the cart.

• Do Not block the ventilation holes on the cart. Proper air flow

is required for safe operation of equipment.

• Cart with computers should be keep in a room with a

maximum temperature not to exceed 77° F or 25° C.

Thread the loaded Cable Wand through the hole above adapter holder

Push the loaded Cable Wand	Twist the Cable Wand so the trough
about 12” into the cart with	faces DOWN and the Mag-Safe cable
the cable trough facing UP	will drop into the slot, as shown
	Adapter Holders & Duck-
	Head Holders
	Each computer slot in the front of the
	cart is complemented in the back with
	its own pre-numbered Adapter Holder,
	directly behind the computer slot and
	accessible through a cable pass-thru
	hole. Removable Duck-Head Plugs
	have a handy storage place, too.
	Power Plug Whips Included
	Your new Bretford Cart for Apple
	Laptop Computers features short
	Power Whips which plug directly into
	the Computer’s Adapter, eliminating
	long power cords and creating
	specialized cable storage. No more
	miles of cables to try and keep track
	of. Each adapter and its cord set is
	wrapped and numbered, easy to
	identify and easy to manage.

Connect the Power Plug Whip to the adapter (as shown) and place the adapter in its specific, numbered compartment, directly behind its numbered computer slot.

Clear Cable Trap Once Cable Plugs are in their slots, release thumb screws, shift the clear plastic cord trap to the right. Retighten thumb screws.

LED Lights

on the Power Module keep you informed at a glance of what’s going on in the cart

Auxiliary

Outlet

on the Power Module allows you to use a printer

Directional Locking Casters

can be locked as a rigid caster for easy rolling down the hallway, unlocked to swivel for easily getting into tight spaces

Compact

Design

Although this cart can store & power

Front

Storage Tub Inside for extra cables & connectors

Security

Both front & back doors with programmable combination padlocks

• Maximum weight of accessories on top of cabinet is 25

pounds. Do not block ventilation holes when charging

batteries.

• Avoid loading equipment in the cart in a uneven fashion.

Uneven weight distribution could cause a hazardous

condition.

Each Adapter Cable Set has a Numbered Slot in the Back & the Front

Each computer slot comes pre-numbered, with a slot especially designed for the MagSafe® Cable Plugs. Once the Cable Plugs are all hanging in their correct slot, the Clear Cable Trap can be engaged, snugly trapping the cable so that it is always available at the right place and the right length at the right time.

“A place for everything, & everything in its place.”

up 30 laptops, the exclusive quiet-glide casters and compact size make it very easy to move around

Back

• This cart is not designed to be operated by a child or student.

Adult operation and supervision is recommended at all times.

• Although this cart is designed to support the transport of

equipment within a school campus, it is not designed for

outdoor use.

• Liquids should not be stored in, set on or placed inside this

unit.

• Do not pull cart. Always push the cart using the ergonomic

handles.

• Engage locking casters when cart is not in transit.

You know from personal experience the value of keeping your closet neat and organized. You know exactly where everything is when you open the door. So Bretford developed a “closet” for all the cords and cables associated with your Laptop Computers.

Your 30 Laptop Mobility Cart has its own “Cable Clutter Closet” – a lockable compartment at the back of the cart especially designed to keep all the cables away from the computers and the hands that retrieve those

The interior Divider Panel separates the cart so that 75% of the cart is dedicated to the computers in the front and 25% is dedicated to cables and power adapters in the back. Holes in the Divider Panel allow the computer connector cables to pass thru and be easily connected to the computers for charging.

By separating the computer from its power adapter, you minimize the amount of heat beside the computer battery, allowing it to charge at a lower temperature,

• Only the IT Administrator can have access

to the Cable Clutter Closet, since it has its own

programmable Combination Padlock.

• The Power Whips eliminate 6 feet of cable

for each computer, plugging directly into the

power adapter. Less cable and less weight.

• Special Compartments for each power

adapter and its cables provide individual spot

for each cordset.

• Comes with appropriate Laser Numbers

Cable Clutter Closet keeps the

cable sets and adapter bricks organized, everything in its place, with easy access

Ships 100%

Assembled

12 Year Warranty

on the Cabinet

3 Year Warranty

on Electrical

• Use extra caution on ramps and thresholds.

computers from the cart.

allowing the battery to charge faster.

coding the computers, the slots & cable sets.

11000 Seymour Avenue Franklin Park, IL 60131 USA

800 521 9614

bretford.com/apple