Assembly
To assemble the cart:
1.Slide the lifting pedal into the pedal shaft and secure in place with the
2.Place the handle in the handle sockets and secure with the
Handle | Pressure |
| Release Pedal |
Lifting Pedal |
|
| |
Hex Bolt |
|
| Handle |
| Hex Bolt |
Figure 3. Assembly.
To reduce the risk of serious personal injury when using this equipment:
•Keep hands out of the scissor lift to prevent serious pinching and crushing injuries.
•DO NOT exceed the 330 lb. load capacity.
•Lock the casters when loading and unload- ing the cart.
•Balance the load evenly in the center of the cart.
•Transport the load in the fully lowered posi- tion to prevent tipping.
Operations
Keep hands away from the scissor lift to prevent seri- ous crushing injuries.
•Lock casters whenever the cart is stationary.
•Balance the load evenly in the center of the cart.
•Pump the lifting pedal to raise the table.
•Push the pressure release pedal to lower the table (Figure 3).
Note: Always lower the table when not in use.
Maintenance
•Fully lower the tabletop when not in use.
•Wipe all dirt and dust off the table cart.
•Apply light oil to the surface of the hydraulic jack ram.
•If the lifting pedal fails to raise the table, remove the plug on the top of the hydraulic jack. Add oil until full, replace the plug, then pump the handle several times with the pres- sure release valve open to bleed the air out of the system.
If you need additional help with this procedure, call our service department at: (570)
T10041