Napoleon Fireplaces BGD42P Using Flexible Vent Components, Vertically and plumb. Attach the air

14

USING FLEXIBLE VENT COMPONENTS

Use only approved aluminum flexible liner kits marked:

"Wolf Steel Approved Venting" as identified by the stamp only on the 7” outer liner.

HORIZONTAL AIR TERMINAL INSTALLATION

AVENT SHIELD MUST BE USED IF THE WALL TERMINAL IS INSTALLED ON COMBUSTIBLE, EXTERIOR SURFACES.

1.Cut or frame a hole in an exterior wall with a minimum round or square opening of 10½ inches. Secure the firestop spacer over the opening to the interior wall.

2.Stretch the 5" diameter aluminum flexible liner to the required length taking into account the additional length needed for the finished wall surface. Slip the liner a mini- mum of 2" over the inner sleeve of the air terminal and secure with 3 #8 screws. Apply a heavy bead of the high temperature sealant.

3.Using the 8" diameter flexible aluminum liner, slide over the outer combustion air sleeve of the air terminal and secure with 3 #8 screws. Seal as before.

FIGURE 18

The air terminal mounting plate may be recessed into the exterior wall or siding by 1½", the depth of the return flange.

FIGURE 19

4.Insert the liners through the firestop maintaining the required clearance to combustibles. Holding the air termi- nal (lettering in an upright, readable position), secure to the exterior wall and make weather tight by sealing with caulking (not supplied).

For safe and proper operation of the fireplace, follow the venting instructions exactly.

All inner exhaust and outer intake vent pipe joints may be sealed using either Red RTV high temp silicone seal- ant or Black high temp Mill Pac with the exception of the fireplace exhaust flue collar which must be sealed us- ing Mill Pac (not supplied).

5.Apply a heavy bead of the high temperature sealant, Mill Pac, to the inside of the 5" liner approximately 1" from the end. Slip the liner a minimum of 2" over the fireplace vent collar and secure with 3 #8 screws.

6.Using the 8" diameter flexible aluminium liner, apply sealant, slide a minimum of 2" over the fireplace combus- tion air collar and secure with 3 #8 screws.

7.If more liner needs to be used to reach the fireplace, couple them together as illustrated. The vent system must be supported approximately every 3 feet for both vertical and horizontal runs. Use noncombustible strapping to maintain the minimum 1" clearance to combustibles.

8.The heat shield must

be installed only when ter-	FIGURE 20
minating horizontally with
no vertical rise. Remove
the two screws nearest
the vent collars on the top
of the fireplace. Align the
vent shield (supplied) and
secure.

VERTICAL AIR TERMINAL INSTALLATION

1.Fasten the roof support to the roof using the screws provided.

The roof support is optional. In this case the venting is to be adequately supported using either an alternate method suitable to the

authority having

ROOF SUPPORT	jurisdiction or the optional
r o o f	support.

2.Stretch the inner aluminum flex liner to the required length. Slip the liner a minimum of 2” over the inner sleeve of the air terminal connector

INNER and secure with 3 #8 screws. Seal SLEEVEusing a heavy bead of the high

temperature sealant.

AIR	3. Repeat using the outer aluminum flex
CONNECTOR	liner.
TERMINAL

4.Thread the air terminal connector / liner assembly down through the roof.

HIGH		The air terminal must be located
SEALANT
TEMPERATURE
INNER FLEX		vertically and plumb. Attach the air
LINER		terminal connector to the roof support,
OUTER FLEX
LINER		ensuring that the top of the air terminal
DO NOT CLAMP	is 16” above the highest point that it
THE FLEXIBLE	penetrates the roof.
ALUMINUM LINER

W415-0381 / E / 02.09.06