LEAK TESTING INSTRUCTIONS
DO NOT USE A FLAME TO LEAK TEST.
LEAK TESTING: This must be done before initial use, annually and whenever any gas components are replaced or serviced. No smoking while performing this test, and remove all sources of ignition. See Leak Testing Diagram for areas to check.
1.Turn all burners controls to off. Turn supply valve on.
2.Brush a half and half solution of liquid soap and water onto all joints and connections of the regulator, hose, manifolds and valves.
3.Bubbles will indicate a gas leak. Either tighten the loose joint or replace the part with one recommended by the dealer.
4.If the leak cannot be stopped, shut off the gas supply, disconnect it and have the barbecue inspected by your gas supplier or dealer. Do not use the appliance until the leak has been corrected.
5.Turn off gas supply.
REGULATOR
The following table lists input values for the appliance.
BURNER | ORIFICE SIZE | HEAT INPUT | GAS USAGE (TOTAL) | ||
| I | II | (TOTAL) | PROPANE | BUTANE |
MAIN | 63 | 65 | 16.4 kW | 1173 g/h | 1192 g/h |
BACK | 56 | 59 | 7.6 kW | 543 g/h | 553 g/h |
SIDE | 60 | 64 | 4.5 kW | 322 g/h | 327 g/h |
Certified Gases / Pressures - Check rating plate to ensure that it corresponds with following list.
Gas Category | I3B/P(30) | I3B/P(50) | |
Orifice Sizes (see above) | I | I | II |
Gases / Pressures | Butane 30mbar | Butane | Butane 50mbar |
| Propane 30mbar | Propane 37mbar | Propane 50mbar |
|
|
|
|
Countries | DK, FI, NL, NO, | BE, ES, FR, GB, | DE, AT |
| SE | IE, IT, PT |
|
The regulators for both butane and propane must have a rating of at least 1500 g/h. Do not tamper with or modify regulator. Use only regulators which supply the pressure listed in the table above.
5