Vanguard Heating VMH26TPC, VMH26TNC, 000 to 26 Operating Fireplace, Lighting Instructions

Page 19

INSTALLATION

Continued

Equipment

Shutoff Valve

Propane/LP

Supply Tank

Figure 27 - Checking Gas Joints for Propane/LP Gas (Shown with Optional Mantel)

Equipment

Shutoff Valve

Gas Meter

Figure 28 - Checking Gas Joints for

Natural Gas (Shown with Optional Mantel)

WHAT TO DO IF YOU SMELL GAS

Do not try to light any appliance.

Do not touch any electric switch; do not use any phone in your building.

Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

If you cannot reach your gas supplier, call the fire department.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don’t try to repair it, call a qualified service tech- nician or gas supplier. Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a quali- fied service technician to inspect the appli- ance and to replace any part of the control system and any gas control which has been under water.

LIGHTING

INSTRUCTIONS

WARNING: You must oper- ate this fireplace with the fire- place screen in place. Make sure fireplace screen is installed be- fore running fireplace.

OPERATING FIREPLACE

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

NOTICE: During initial operation of new fireplace, burning logs will give off a paper-burning smell. Orange flame will also be present. Open window to vent smell. Operate fireplace on HI position to burn off odor. This will only last a few hours.

1.STOP! Read the safety information start- ing in column 1.

2.Make sure equipment shutoff valve is fully open.

3.Turn control knob clockwise to the OFF position.

4.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety information starting in column 1. If you don’t smell gas, go to the next step.

113111-01A

www.desatech.com

19

Image 19
Contents What to do if YOU Smell GAS Shown with Optional Cabinet Mantel/Hearth Base AccessoryTable of Contents Safety Information Product Identification Local CodesAssembly Product FeaturesUnpacking Unusually Tight Construction AIR for Combustion VentilationProviding Adequate Ventilation Assembling HoodConfined and Unconfined Space Determining FRESH-AIR Flow for Fireplace LocationDetermining if You Have a Confined or Unconfined Space Ventilation Air From Inside Building Ventilation AIRVentilation Air From Outdoors Installation Items InstallationCheck GAS Type Locating Fireplace BUILT-IN Fireplace InstallationRough Opening for Installing Wall Mantel Clearances for Built-In Installation Optional Mantel InstallationRemoving Valve Cover Shield Installing Blower Accessory GA3450TRemoving Upper Louver Assembly Assembling Perimeter Trim Trim Shipped with MantelRemoving Valve Cover Shield Installing Blower AssemblyFor Built-In Installation Installing Switch Plate to Valve Cover ShieldAttaching Wood Base to Solid Floor Connecting to GAS SupplyExtension Cord Installation Items Needed Connecting Equipment Shutoff Valve to Heater ControlPressure Testing Fireplace Gas Connections Pressure Testing Gas Supply Piping SystemChecking GAS Connections Operating Fireplace For Your Safety Read Before LightingLighting Instructions Shutting Off Fireplace Manual Lighting ProcedureTo Turn OFF GAS To Appliance Thermostat Control OperationPilot Flame Pattern Inspecting BurnerOperating Blower Burner Flame PatternAir Passageways Cleaning MaintenanceBurner Injector Holder and Pilot AIR Inlet Hole CabinetObserved Problem Possible Cause Remedy TroubleshootingSee Cleaning and Mainte Residues from manufacturing Statement above Gas leak. See WarningReplacement Parts SpecificationsService Hints Technical ServiceIllustrated Parts Breakdown Parts List Accessories Information Video Cleaning KIT GCKCorner Mantel with Full Hearth Base Cabinet Mantel and Full Hearth BaseKeep this Warranty Warranty InformationLimited Warranty VENT-FREE Compact Classic Hearth Fireplace