Heat & Glo LifeStyle PCFML-HNG Appliance Setup, Burner Assembly, All Models, Natural Gas Models

6 Appliance Setup

A. Burner Assembly

All Models

•Remove the burner assembly and check for damage. Do not use damaged components.

•Position the burner assembly in the desired location. This location must be adjacent to the gas supply line. You must have easy access to the gas valve control knob after it is installed and connected to the gas supply because the ON/OFF gas valve is used to turn the burner on and off.

Natural Gas Models

•Connect the ON/OFF gas valve of the appliance to the incoming gas supply line. See Figure 6.1. Make certain all gas connections are tight.

•Turn the ON/OFF valve at the appliance slowly to the “ON” position. All connections must be tightened and checked for leaks with a commercially available, non-corrosive leak check solution. Be sure to rinse off the solution when done leak testing.

	Locating
"ON/OFF"	Button
Valve
	Check fittings
	for leaks
Figure 6.1 Natural Gas Burner Assembly

LP Gas Models

•Make sure the tank valve is turned completely off (clockwise).

•Ensure the tank valve has the proper external mating threads (tank valve marked “USE WITH TYPE 1”).

•Inspect the hose shipped with the appliance for any damage. Do not use if there is evidence of damage.

•Connect the end of the hose onto the ON/OFF gas valve of the appliance. Make sure it is secured tightly.

•Connect the regulator assembly to the tank valve. Hand tighten only (clockwise). Do not use a wrench to tighten! Use of a wrench may damage the quick closing nut and result in a hazardous condition. See Figure 6.2.

•Position the hose out of pathways where people might trip over it or in areas where the hose might be subject to accidental damage.

•Open the tank valve fully (counterclockwise). Turn the ON/ OFF valve slowly to the “ON” position. All connections must be tightened and checked for leaks with a commercially available, non-corrosive leak check solution. Be sure to rinse off the solution when done leak testing. If a leak is found, turn the tank valve off and do not use the appliance until repairs can be made.

"ON/OFF"			Burner
Gas Valve		Locating
	Flex		Assembly
		Button
Connector
Propane	Check fittings
	for leaks
Regulator Hose
Figure 6.2 Propane Gas Burner Assembly

10 Heat & Glo LifeStyle Collection • Patio Campfire • Rev B • 08/08