Desa VC42P Operating Fireplace, For your safety Read before lighting, Lighting Instructions

Fireplace

Installation

Continued

6.Install rear brick panel first. Rest bottom edge of panel on back edge of burner assembly (see Figure 44).

7.Install left side brick panel by sliding it be- tween the burner assembly and the side of the firebox (see Figure 44).

8.Install the right brick panel using the same method described in step 6 for left brick panel.

9.Replace deflector shield using screws removed in step 4.

10.Using screws removed in step 4, replace plenum and attach to burner.

11.Using screws removed in step 3, replace log/grate assembly. Be careful when replac- ing log/grate assembly not to chip logs on burner.

12.Install lava rock and glowing embers. See

Installing Lava Rock and Glowing Embers, page 26.

13.Close glass door and lock latches on top and bottom of door and replace screen. See Remov- ing Glass Door, steps 5 and 6 on page 25.

14.Close top and bottom louvers.

Left Side Brick

Panel

Rear Brick

Panel

Figure 44 - Installing Rear Brick Panel

Operating Fireplace

for your safety

Read before lighting

WARNING: If you do not fol- low these instructions exactly, a fire or explosion may result causing property damage, per- sonal injury or loss of life.

A.This appliance has a pilot which must be lighted by hand. When lighting the pilot, follow these instructions exactly.

B.BEFORE LIGHTING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•Do not try to light any appliance.

•Do not touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.

C.Use only your hand to push in or turn the gas control knob. Never use tools. If the knob will not push in or turn by hand, don't try to repair it, call a qualified service technician.

Force or attempted repair may result in a fire or explosion.

D.Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

lighting

instructions

1.STOP! Read the safety information above.

2.Open lower louver panel.

3.Turn off all electric power to the fireplace.

4.Push in gas control knob slightly and turn

clockwise to “OFF”.

5.Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor.

If you smell gas, STOP! Follow “B” in the safety information above. If you don't smell gas, go to the next step.

6.The pilot is located by the main burner and should not require accessing for lighting.