Hearth and Home Technologies GO30MTCH, GO24MTCH Design and Installation Considerations

Page 3

WARNING

Improper installation, adjustment, alteration, service or maintenance can cause injury or property damage. Refer to the owner’s information manual provided with this appliance. For assistance or additional information consult a qualifi ed installer, service agency or the gas supplier.

CAUTION

Sharp Edges

Wear protective gloves and safety glasses during installation.

A.Design and Installation Considerations

The Gas Log Hearth Kit consists of the following:

Log Set

Burner/Pan Assembly

Grate Assembly

Rock Wool

Sand

Lava Rock

Damper Stop

Vermiculite

Platinum Embers

B. Tools and Supplies Needed

Tools and supplies normally required for installation:

Pliers

Phillips screwdriver Tape measure Crescent wrenches Gas shutoff valve

Non-corrosive leak check solution 3/4 in. wrench, 7/16 in. wrench

WARNING

HOT! DO NOT TOUCH.

SEVERE BURNS MAY RESULT.

CLOTHING IGNITION MAY RESULT.

Glass and other surfaces are hot during operation and cool down.

Keep children away.

CAREFULLY SUPERVISE children in same room as appliance.

Alert children and adults to hazards of high temperatures.

Keep clothing, furniture, draperies and other combustibles away.

-Review proper placement of logs, rockwool, lava rock and vermiculite.

-Check the wiring.

-Ensure there are no gas leaks.

-Ensure the flow of combustion and ventilation air is not obstructed (front grilles and vent caps).

Before installing into a solid fuel burning fi replace, the chimney and fi rebox should be inspected and cleaned to remove soot, creosote, ashes, paint, bird nests etc.

Annual examination of the chimney must be performed by a qualifi ed agency to ensure proper ventilation of fl ue gases created by this appliance.

WARNING

Fire Risk

Exhaust Fumes Risk

Do NOT use this appliance as a “vent-free heater.

The flue must be permanently open according to Tables 1 and 2.

C. Important!

Do not remove any of the attached metal plates, which contain important safety and operating information.

Keep the appliance area clear and free of all combustible materials, gasoline and other fl ammable vapors and liquids.

Any safety screen or guard removed during servicing must be replaced before operation.

Aqualified service technician must perform installation and repair. The appliance should be inspected and cleaned annually by a qualifi ed service technician. More frequent cleaning may be required due to excessive lint, dust, pet hair, etc. It is imperative that the control compartments, burners and air passageways are unobstructed during operation.

Have the chimney and adjacent structure inspected and cleaned by qualifi ed professionals. Hearth & Home Technologies recommends that NFI or CSIA certifi ed professionals, or technicians under the direction of certified professionals, conduct a minimum of an NFPA 211 Level 2 inspection of the chimney.

Replace component parts of the chimney and fireplace as specifi ed by the professionals.

Ensure all joints are properly engaged and the chimmney is properly secured.

Do not allow fans to blow directly into the fi replace. Avoid any drafts that alter burner fl ame pattern.

Do not use a blower insert, heat exchanger insert or other accessories not approved for use with this appliance.

Hearth & Home Technologies • Grand Oak Match Light Gas Log Sets • 4004-300 Rev C • 12/05

3

Image 3
Contents Commonwealth of Massachusetts What to do if you smell gasListing Label Information/Location Homeowner Reference InformationDesign and Installation Considerations Tools and Supplies NeededFire Risk Exhaust Fumes Risk Fire Risk Explosion Risk Appliance CertificationGas Supply Connection Gas PressureFor Factory Built Fireplaces For Minimum Fireplace DimensionsNegative Pressure Asphyxiation RiskMeasure Firebox Inspect the Appliance and ComponentsFire Risk Explosion Risk Personal Injury Risk For Natural Gas InstallationDamper Stop Clamp Damper Stop Installation Instructions24 in. Grand Oak Series Logs GO24 24 in. Grand Oak Series GO24 Log Placement Instructions 30 in. Grand Oak Series Logs GO30 Step 30 in. Grand Oak Series GO30 Log Placement InstructionsPossible cures if spilling occurs Inspect the Venting SystemLighting Instructions- Match Light For Your Safety Read Before LightingDo not allow soot to build up on the logs Cleaning and Maintenance InstructionsFequently Asked Questions What sort of maintenance do gas logs require?Grand Oak Gas Logs Replacement PartsDescription of Part Qty Decorative GAS LOG Limited Warranty WarrantyDo not Discard this Manual