Vermont Casting ODSHR42 manual Installing the Chimney System, Proper Firestop Spacer Installation

ODSHR Outdoor Woodburning Fireplace

Installing the Chimney System

Start by attaching the first chimney section to the collar on top of the fireplace.

Install the pipe as pictured in Figure 17. When you get a good lock, you will hear the pipe clearly snap together. Once sections are snap-locked in place, it is extremely difficult to get them apart. Make sure the pipe is firmly snapped and locked together as each pipe section is mounted.

When installing elbows, only outer pipe will snap- lock. Middle pipes simply slide into position. Be sure to always attach straps on upper elbow to a structural framing member. (Fig. 18)

Continue installing the pipe as required until pipe is installed up through the ceiling. At this point, you must install a firestop spacer.

Installing the Firestop Spacer

in the Ceiling Hole

A firestop spacer is used to keep pipe spaced properly and required for safety.

Nail the firestop spacer (at each corner) to the framing members of the ceiling hole. NOTE: A firestop spacer is not required at the roof.

Hole sizes listed in Figure 12 for angled firestop spac- ers provide minimum required air space to chimney pipe for ceiling thickness up to 8" (203 mm). When combined thickness of ceiling material, ceiling joists and flooring material exceeds 8" (203 mm), adjust- ments must be made in framing to assure that minimum air spaces to chimney are maintained.

Proper Firestop Spacer Installation

Figure 19 shows different installation procedures for both an area that is an attic and an area that is not an attic.

Inner Pipe

Section

Pipe

Rim Hem

Lance

Pipe

Rim

FP558SHR

Fig. 17 Install pipe, listening for the snap-lock to fasten.

Support Structure

Elbow Strap (must be tight)

Ceiling

Elbow StrapHole

Framing

Angle Firestop

Chimney Support

Angled StrapStrap

(must be tight)

FP270/271

Fig. 18 Attach straps to a structural framing member.

If the area above the ceiling is not an attic, po- sition the firestop spacer with the flange on the ceil- ing side and the angled portion extending up into the hole.

If the area above the ceiling is an attic, position the firestop spacer with the flange on the top of the framed hole and the angled portion extending down into the hole.

12

	Attic Installation	Ceiling Installation
	Nails (4)
	Firestop Spacer		Joist
	Joist		Firestop
			Spacer
	Flange Down Into Hole		Nails (4)
		Flange Up Into Hole	FP285
Fig. 19	Installing firestop spacer.
			20002264