21
BIPRO600 BUILT-IN INSTRUCTIONS
4 x | 3/8”(10mm) |
| |
|
This grill is designed for masonry,
1.Attach side mounting brackets to each side of the grill using #14 x 1/2" screws
2.Lay the rear trim piece across the back of the opening. To keep it in place, a dab of silicone may be applied to each wing of the rear trim.
3.Lower the unit in place, the wings on the rear trim should be under the side mounting brackets. Connect the flex supply line to the fitting at the end of the manifold.
4.The entire installation must be leak tested before operating the unit.
www.napoleongrills.com