ASSEMBLY
•BEFORE ASSEMBLY READ ALL INSTRUCTIONS CAREFULLY.
•ASSEMBLE UNIT ON A CLEAN, FLAT SURFACE.
•TOOL NEEDED: PHILLIPS HEAD SCREWDRIVER
A
1 |
| 5 | |
4 | A | ||
|
Tension
Nuts
STEP 1
Position wheel (5) on bottom of smoker body (1) as shown.
Insert adjustable screw leg (4) into bottom of wheel (5).
Secure wheel (5) to bottom of smoker body (1) using phillips screws (A).
Repeat step for opposite side.
Note: Set adjustable screw leg height by turning clockwise/coun- terclockwise so that smoker is level when unit is upright. Once level, secure back leg positions with attached tension nuts.
6
1
Stabilizing
Screw
Keyhole
STEP 2a
Position control panel (6) on top of smoker body (1) as shown.
Align slots on wire connecter from control panel with tabs on wire connecter on smoker as shown and connect together.
STEP 2b
Mount control panel by inserting stabilizing screw head into keyhole.
Note: Stabilizing screw may need slight adjustment for snug fit.
6