Centro G50205 Lighting the Second Burner, Lighting the Side Burner, Visually Check Burner Flame

Page 10

[CEN 025] G50205 BBQ Manual E 11/4/05 6:54 PM Page 8

H I

LOW

Lighting the Second Burner

•Turn the second control knob on the main control panel to the “HIGH” position. The unlit burner will automatically ignite.

Lighting the Side Burner

Use the push-button igniter on the main control panel and the right control knob on the side burner panel.

•Push in and turn the right control knob to the “HIGH” position.

•Push the igniter button until a loud click is heard, which is the

spark being formed. Repeat several times if the burner does not light.

•If the burner does not light after several tries, turn the right control knob off and wait 5 minutes for the gas to clear.

•Repeat the above instructions. If the side burner still does not light,

refer to the troubleshooting section for help or light the burner manually.

Note: The side burner is designed to accept a maximum weight of 20 lb. Do not overload the side burner.

Lighting the Side Burner with a Match

•Place match in front ring of provided match holder.

•Place a lighted match through the hole to within 16 cm (1/2˝ ) of the side burner.

•Push in and turn the burner knob to the “HIGH” position. At this point, the burner should light, if it doesn’t after 5 seconds, turn the

control knob back to the “OFF” position and wait for the gas to clear.

•Wait 5 minutes, and then repeat the manual lighting procedure. If after three tries the burner still does not light, review the troubleshooting guide for help.

Shutting Down the Barbecue After Use

•Turn off the gas cylinder valve.

•Turn the burner control valve to the “OFF” position.

This sequence is important as it prevents residual gas from being left in the system under pressure and will make the next use easier.

Visually Check Burner Flame

Take off the grates and heat shield. Light burners. Adjust the flame by turning the knobs from “HIGH” to “LOW”. The flames will be smaller when the knobs are in the “LOW” posi- tion. Always check flame prior to each use. Perform flame check for side burner.

8

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Serial # B L E O F C O N T E N T S D I T I O N a L R N I N G S Installation I N F O R M a T I O NE O F L P G a S C Y L I N D E R To Avoid Unnecessary Risks Cylinder must also be equipped withL L I N G T H E L P C Y L I N D E R I O R T O U S I N G Hose and Regulator InspectionF E T Y H O S E D R E G U L a T O R Perform a Leak Test To Reset The Gas Regulator Safety DeviceF E T Y A K T E S T I N G Following Must Be CheckedG H T I N G E G R I L L R N I N G If the Selected Burner does not LightTurning The Burners Off Match Lighting The Main BurnersLighting the Side Burner with a Match Lighting the Second BurnerLighting the Side Burner Shutting Down the Barbecue After UseGuide to Rotisserie Cooking Match LightingP S O N U S I N G U R R O T I S S E R I E Balancing the FoodItem No Quantity Specification R T S L I S T I N G F O R1 1 0 2 P R O P a N E G 5 0 2 0 1 1 0 6 2 N a T U R a L G a S G 5 0 2 0 1 1 0 6 2 N a T U R a L G a S G 5 0 2 0 S E M B L Y I N S T R U C T I O N S Tools Needed for AssemblyHardware Pack List CEN 025 G50205 BBQ Manual E 11/4/05 654 PM Place the top lid and burner box assembly A+B onto the cart CE + CF CEN 025 G50205 BBQ Manual E 11/4/05 654 PM For propane model only #85-1102 F O R M a T I O N O N T U R a L G a S M O D E L Connecting to Gas LineDisconnecting From Gas Line Natural Gas Supply ConnectionS T R I B U T O R CEN 025 G50205 BBQ Manual E 11/4/05 654 PM
Top Page Image Contents