Centro 85-1620-6 manual Fig. D, Very IMPORTANT!! This step must be followed

Page 13

Fig. A

Stem valve

Fig. C

Fig. D

5

Replace Rotisserie and Sear Zone Control knobs (Figure A). Only the 3 Main Burner Valves must be worked on in this step. Using the screwdriver tool provided, place the end of the screw driver into the valve stem (located on the front of the Control Panel as shown in Figure B). Turn the connector 90 degrees to a vertical position.

VERY IMPORTANT!! This step must be followed.

Fig. B

Starting horizontal (LP) position (Fig.C).

Final vertical (NG) position (Fig.D).

1 1

Image 13

Contents Serial # F E T Y M B O L S Installation F E T Y P R E C a U T I O N SFor residential use only. Do not use for commercial cooking E a N D C a R EFig. a Fig. C Hose Check Be sure gas hose is tightly connected to gas sourceIf you experience the following Natural Hazard SpidersStop Storing Your GrillPage NG hose Orifice removal tool Screw driver NG orifice S E M B L Y I N S T R U C T I O N S Fig. a Fig. D Very IMPORTANT!! This step must be followed Fig. DFig. F Step cannot be forgotten Rotisserie Burner Orifice Replacement LP orifice Gas Supply Conversion S T R I B U T O R