6.Fromundersideofleftsideshelf,remove2screwsand
lockwashersto assemblytowelrackandbezelsHangthe Figure 9 twotrashclips(R)totherightsideburnershelfedge(Fig.6).
7.Remove(3)1/4x 3/8"Phillipsheadscrewsand(3)1/4" lockwashersonsideshelffrontpanelThenattachfront. paneltosideshelfusingthesame3screwsandlock washers(Fig.7).
8.Attachleftsideshelfin samemannerasdescribedfor rightsideshelfin steps2and3.
InstallingIgniterModule
Locate igniter module at right side of cabinet. Remove silver battery cap and hexagon plastic nut from battery box. Insert threaded stem of battery box through hole in side burner control panel as shown (Fig. 8). Tighten it to panel using hexagon plastic nut. Replace battery cap.
Figure | 10 |
Installing Side Burner Valve | 5/64" hex wrench |
1. Locate side burner valve in right side of grill cabinet. |
|
Remove 2 screws and washers from valve. Insert valve |
|
stem through hole in front panel. Place side burner control |
|
knob bezel over valve stem, and attach bezel and valve |
|
stem to front panel with same 2 screws and washers (Fig. 9). |
|
2. Remove rubber decorative band from control knob to |
|
reveal set screw access hole. Push control knob over valve |
|
stem. Secure knob to stem by using included 5/64" hex |
|
wrench to tighten set screw (Fig. 10). |
|
3. Plug side burner igniter wire into igniter module (Fig.11). |
|
4.Ensure small igniter wires into igniter module (Fig. 12). |
|
5. Assembly 2pcs tower racks to side shelf control panel |
|
(Fig.13).
Figure 11
I Whensure thatyouallhavescrewsfinishedand nutsassemblingare tightgrill,and makesecure.
Figure 6
Figure 7
Figure 12
Figure 8
8