Kenmore 415.1613911 manual Troubleshootinc, Fire coming through control panel, On next

Page 21

EMERGENCIES: Jf a gas leak cannot be stopped, or a fire occurs due to gas leakage, call the fire department.

Gas leaking from

cracked/cut/burned

hose.

Gas leaking from LP cylinder.

Gas leaking from LP cylinder valve.

Gas leaking between

LP cylinder and

regulator connection.

Fire coming through control panel.

Grease fire or

continuous excessive

flames above cooking

surface.

• Damaged hose.

•Mechanical failure due to rusting or mishandling.

•Failure of cylinder valve from mishandling or mechanical failure.

•Improper installation, connection not tight, failure of rubber seal.

•Fire in burner tube section of burner due to blockage.

•Too much grease buildup in burner area.

•Turn off gas at LP cylinder or at source on natural gas systems. If the hose is cracked or cut but not burned, simply replace

valve!hose/regulator.

If the hose is

burned, the cause

could be

other than

a faulty

valve!hose!regulator.

Discontinue

use of

grill until a

plumber

or gas technician

has investigated

and

corrected

the problem.

 

 

•Replace LP cylinder.

•Turn off LP cylinder valve. Return LP cylinder to gas supplier.

•Turn off LP cylinder valve. Remove regulator from cylinder and visually inspect rubber seal for damage. See LP Cylinder Leak Test and Connecting Regulator to the LP Cylinder.

•Turn off control knobs and LP cylinder valve. Leave lid open to allow flames to die down. After fire is out and grill is cold, remove burner and inspect for spider nests or rust. See Spider

Alert and Cleaning the Burner Assembly sections of this Use & Care Guide.

•Turn off control knobs and LP cylinder valve. Leave lid open to allow flames to die down. After cooling, clean food particles and excess grease from inside firebox area, grease tray, and other surfaces.

Troubleshootinc

Burner(s) will not light using ignitor.

(See Electronic Ignition

Troubleshooting also)

Continued on next

page.

GAS ISSUES:

 

 

 

 

 

 

 

 

 

 

 

 

" Trying

to

light wrong

burner.

•

See instructions on

control

panel

and

in Use and

Care section.

• Burner

not

engaged

with control valve.

•

Make

sure valves

are

positioned

inside

of burner

tubes.

 

• Obstruction

in burner.

•

Ensure burner tubes are not obstructed

with spider webs

or other

 

 

 

 

 

matter. See cleaning section of Use and Care.

 

 

• No gas

flow.

 

•

Make

sure LP cylinder

is

not empty.

If

LP cylinder

is not

empty,

 

 

 

 

 

refer to _Sudden drop in gas flow."

 

 

 

 

•Vapor lock at coupling nut to LP cylinder.

•Coupling nut and LP cylinder valve not fully connected.

ELECTRICAL ISSUES:

•Electrode cracked or broken; _sparks at crack."

•Electrode tip not in proper position.

•Wire and!or electrode covered with cooking residue.

•Wires are loose or disconnected.

•Wires are shorting (sparking) between ignitor and electrode.

•Dead battery.

•Turn off knobs and disconnect coupling nut from LP cylinder. Reconnect and retry.

•Turn the coupling nut approximately one-half to three-quarters

additional turn until solid stop. Tighten by hand only - do not use tools.

•Replace electrode(s).

Main Burners:

•Tip of electrode should be pointing toward gas port opening on

burner. The distance should be 1/8" to 1/4". Adjust if necessary. Sideburner:

•Tip of electrode should be pointing toward gas port opening on burner, the distance should be 1/8" to 3/16". Adjust if necessary.

•Clean wire and/or electrode with rubbing alcohol and clean swab.

•Reconnect wires or replace electrode/wire assembly.

•Replace ignitor wire/electrode assembly.

•Replace with a new AA-size alkaline battery.

464224211 ° 21

Page 20 Page 22
Image 21
Page 20 Page 22
Contents ModeJ Ie ore EliteIf you smell gas Seeratinglabelongrillfor serialnumberFor resldentlal use only. Do not use for commercial Cooking Sears Installation Service Tools needed for assemblyHeres what the Repair Protection Agreemenff includes Never store a spare LP cylinder under or near LP TankAppliance or in an enclosed area LP Tank Removal, Transport And StorageFor your safety LP Tank ExchangeThread on outside Orifice at end of valve Cannot be stopped do nat try to repair. Call Sears forApartment Dwellers Safety TipsFor Safe Use of Your Grill and to Avoid Serious Storing Your GrillIf ignition does not occur in 5 seconds, turn Open grill lld during LightingBurner controls OFF, wait 5 minutes and repeat Burner and could accidenfly ignite with risk of injuryMatch lighting the Side Burner Figure D Ignitor CheckBurner Flame Check Valve CheckHow To Tell If Meat is Grilled Thoroughly Food SafetyVery iMPORTANT Burner tubes Re-engage valveBulb Replacement Light Operation iNSTRUCTiONSFor outdoor use Circuits IIIIIiMPO ANFTo order Replacement Parts after Using grill Call Unpacking Grill Call For replacementNot Pictured If you are missing hardware or have damaged parts after14,464224211 464224211 Screw 20x3/4Nut Washer464224211 Grease tray Property damageRegulator TAuT,oNBack of right door Install door organizersTroubleshootinc Wires are shorting sparking between ignitor and electrodeFire coming through control panel On nextSudden drop in gas flow or low flame TroubleshootlngIgnitor IgnitionInstalled Troubleshooting Electronic IgnltionConnections not ConnectedIiiiiiiiiiiiiiiiiiiiii!iiY Your Home

415.1613911 specifications

The Kenmore 415.1613911 is a versatile and efficient washing machine designed to meet the needs of modern households. Known for its reliability and performance, this model boasts several features and technologies that enhance the laundry experience while ensuring energy efficiency and effective cleaning.

One of the standout features of the Kenmore 415.1613911 is its large capacity drum, which can handle large loads of laundry, making it ideal for families or those who frequently do laundry. This spacious design minimizes the number of wash cycles required, saving both time and energy.

Equipped with multiple wash cycles and customizable settings, the Kenmore 415.1613911 can accommodate various fabric types and soil levels. Its selection includes options for delicate fabrics, heavy-duty cleaning, and quick wash cycles, providing users with flexibility to choose the perfect cycle for their needs. This adaptability ensures that every load is treated with the care it requires while achieving optimal cleaning performance.

Another significant aspect of the Kenmore 415.1613911 is its advanced technology. The machine features a high-efficiency agitator that promotes thorough cleaning without causing damage to fabrics. This technology effectively removes dirt and stains, ensuring that clothes come out fresh and clean after every wash. Additionally, this model incorporates energy-saving features, including a load-sensing capability that adjusts water levels according to the size of the load, further enhancing its energy efficiency.

The Kenmore 415.1613911 also emphasizes user-friendliness, equipped with a simple control panel that allows users to easily navigate through the various wash options. The clear display ensures that users can quickly select the desired settings and monitor the progress of their laundry.

Durability is another hallmark of this washing machine. Built with high-quality materials, the Kenmore 415.1613911 is designed to withstand the rigors of daily use, providing longevity and reliability.

In conclusion, the Kenmore 415.1613911 is a functional and efficient washing machine that combines large capacity, versatile wash cycles, advanced cleaning technology, and user-friendly features, making it a top choice for families and individuals seeking an effective laundry solution. Its durability and energy efficiency contribute to an overall positive experience, allowing users to enjoy cleaner clothes with minimal effort.
Top Page Image Contents