Kenmore 415.1613911 manual LP Tank, Never store a spare LP cylinder under or near

Page 4

f

x, II

_I

•NEVER store a spare LP cylinder under or near the

appliance or in an enclosed area.

•Never fill a cyllnder beyond 80°/0 full.

•if the information in the two points above is not followed exactly, a fire causing death or serious injury may occur.

•An overfilled or improperly stored cyllnder is a hazard due to possible gas release from the safety relief valve. This could cause an intense fire with risk of property damage, serious injury or death.

•if you see, smell or hear gas escaping, immediately get away from the LP cylinder and appllance and call your fire department.

LP Tank Removal, Transport And Storage

-Turn OFF all control knobs and LP tank valve. Turn coupling

nut counterclockwise by hand only - do not use tools to disconnect. Lift LP tank wire upward off of LP tank collar, then lift LP tank up and off of support bracket. Install safety cap onto LP tank valve. Always use cap and strap supplied with valve.

Failure to use safety cap as directed may result in serious personal injury and/or property damage.

LP

Safety Cap

Retainer Strap

"A disconnected LP tank in storage or being transported must have a safety cap installed (as shown). Do not store an LP tank in enclosed spaces such as a carport, garage, porch,

covered patio or other building. Never leave an LP tank inside a vehicle which may become overheated by the sun.

* Do not store an LP tank in an area where children play.

LP Tank

*The LP Tank used with your grill must meet the following requirements:

*Use LP Tanks only with these required measurements: 12" (30.5cm) (diameter) x 18" (45.7 cm) (tall) with 20 lb. (9 kg.) capacity maximum.

*LP Tanks must be constructed and marked in accordance with specifications for LP Tanks of the U.S. Department of

Transportation (DOT) or for Canada, CAN/CSA-B339, tanks,

spheres and tubes for transportation of dangerous goods. Transport Canada (TC). See LP Tank collar for marking.

*LP Tank valve must have:

*Type I outlet compatible with regulator or grill.

*Safety relief valve.

*UL listed Overfill Protection

Device (OPD). This OPD safety OPD Hand Wheel

feature is identified by a unique triangular hand wheel. Use only LP Tanks equipped with this type of valve.

*LP Tank must be arranged for vapor withdrawal and include collar to protect LP Tank valve. Always keep LP Tanks in upright position during use, transit or storage.

LP Tank in upright position for vapor withdrawal

LP (Liquefied Petroleum Gas)

*LP gas is nontoxic, odorless and colorless when produced. For Your Safety, LP gas has been given an odor (similar to rotten cabbage) so that it can be smelled.

*LP gas is highly flammable and may ignite unexpectedly when mixed with air.

LP Tank Filllng

*Use only licensed and experienced dealers.

*LP dealer must purge new tank before filling.

"Dealer should NEVER fill LP Tank more than 80% of LP Tank volume. Volume of propane in tank will vary by temperature.

*A frosty regulator indicates gas overfill. Immediately close LP Tank valve and call local LP gas dealer for assistance.

*Do not release liquid propane (LP) gas into the atmosphere. This is a hazardous practice.

*To remove gas from LP Tank, contact an LP dealer or call a local fire department for assistance. Check the telephone

directory under "Gas Companies" for nearest certified LP dealers.

4 ° 464224211

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Ie ore Elite ModeJSeeratinglabelongrillfor serialnumber If you smell gasFor resldentlal use only. Do not use for commercial Cooking Tools needed for assembly Sears Installation ServiceHeres what the Repair Protection Agreemenff includes LP Tank Never store a spare LP cylinder under or nearAppliance or in an enclosed area LP Tank Removal, Transport And StorageLP Tank Exchange For your safetyThread on outside Cannot be stopped do nat try to repair. Call Sears for Orifice at end of valveSafety Tips Apartment DwellersFor Safe Use of Your Grill and to Avoid Serious Storing Your GrillOpen grill lld during Lighting If ignition does not occur in 5 seconds, turnBurner controls OFF, wait 5 minutes and repeat Burner and could accidenfly ignite with risk of injuryIgnitor Check Match lighting the Side Burner Figure DBurner Flame Check Valve CheckFood Safety How To Tell If Meat is Grilled ThoroughlyVery iMPORTANT Burner tubes Re-engage valveLight Operation iNSTRUCTiONS Bulb ReplacementFor outdoor use IIIIIiMPO ANF CircuitsUnpacking Grill Call For replacement To order Replacement Parts after Using grill CallNot Pictured If you are missing hardware or have damaged parts after14,464224211 464224211 20x3/4 ScrewNut Washer464224211 Property damage Grease trayTAuT,oN RegulatorInstall door organizers Back of right doorWires are shorting sparking between ignitor and electrode TroubleshootincFire coming through control panel On nextTroubleshootlng Sudden drop in gas flow or low flameIgnitor IgnitionTroubleshooting Electronic Ignltion InstalledConnections not ConnectedYour Home Iiiiiiiiiiiiiiiiiiiiii!iiY

415.1613911 specifications

The Kenmore 415.1613911 is a versatile and efficient washing machine designed to meet the needs of modern households. Known for its reliability and performance, this model boasts several features and technologies that enhance the laundry experience while ensuring energy efficiency and effective cleaning.

One of the standout features of the Kenmore 415.1613911 is its large capacity drum, which can handle large loads of laundry, making it ideal for families or those who frequently do laundry. This spacious design minimizes the number of wash cycles required, saving both time and energy.

Equipped with multiple wash cycles and customizable settings, the Kenmore 415.1613911 can accommodate various fabric types and soil levels. Its selection includes options for delicate fabrics, heavy-duty cleaning, and quick wash cycles, providing users with flexibility to choose the perfect cycle for their needs. This adaptability ensures that every load is treated with the care it requires while achieving optimal cleaning performance.

Another significant aspect of the Kenmore 415.1613911 is its advanced technology. The machine features a high-efficiency agitator that promotes thorough cleaning without causing damage to fabrics. This technology effectively removes dirt and stains, ensuring that clothes come out fresh and clean after every wash. Additionally, this model incorporates energy-saving features, including a load-sensing capability that adjusts water levels according to the size of the load, further enhancing its energy efficiency.

The Kenmore 415.1613911 also emphasizes user-friendliness, equipped with a simple control panel that allows users to easily navigate through the various wash options. The clear display ensures that users can quickly select the desired settings and monitor the progress of their laundry.

Durability is another hallmark of this washing machine. Built with high-quality materials, the Kenmore 415.1613911 is designed to withstand the rigors of daily use, providing longevity and reliability.

In conclusion, the Kenmore 415.1613911 is a functional and efficient washing machine that combines large capacity, versatile wash cycles, advanced cleaning technology, and user-friendly features, making it a top choice for families and individuals seeking an effective laundry solution. Its durability and energy efficiency contribute to an overall positive experience, allowing users to enjoy cleaner clothes with minimal effort.
Top Page Image Contents