Char-Broil 463460708 manual Cleaning the Burner Assembly, Storing Your Grill

Page 9

CAUTION

SPIDER ALERT!

SPIDER AND WEBS

INSIDE BURNER TUBE

If you notice that your grill is getting hard to light or that the flame isn’t as strong as it should be, take the time to check and clean the venturi’s.

VALVE

Cleaning the Burner Assembly

Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.

1.Turn gas off at control knobs and LP cylinder.

2.Remove cooking grates and flame tamers.

3.Remove screws and carryover tubes from rear of burners.

4.Remove screw and washers to disengage burner from bracket on firebox.

5.Remove screws to detach electrode from burner. Electrode should remain in firebox.

6.Carefully lift each burner up and away from valve openings.

We suggest three ways to clean the burner tubes. Use the one easiest for you.

(A) Bend a stiff wire (a light weight coat hanger works well)

into a small hook. Run the hook through each burner

tube several times.

(B) Use a narrow bottle brush with a flexible handle (do not

use a brass wire brush), run the brush through each

burner tube several times.

(C) Wear eye protection: Use an air hose to force air into

CONTROL PANEL

SPIDER WEBS

INSIDE VENTURI

the burner tube and out the burner ports. Check each

port to make sure air comes out each hole.

BURNER

In some areas of the country, spiders or small insects have been known to create “flashback” problems. The spiders spin webs, build nests and lay eggs in the grill’s venturi tube(s) obstructing the flow of gas to the burner. The backed-up gas can ignite in the venturi behind the control panel. This is known as a flashback and it can damage

7.

Wire brush entire outer surface of burner to remove food

 

residue and dirt.

8.

Clean any blocked ports with a stiff wire such as an open

 

paper clip.

9.

Check burner for damage, due to normal wear and corrosion

 

some holes may become enlarged. If any large cracks or

 

holes are found replace burner.

VERY IMPORTANT: Burner tubes must reengage valve

your grill and even cause injury.

To prevent flashbacks and ensure good performance the burner and venturi assembly should be removed from the grill and cleaned before use whenever the grill has been idle for an extended period.

openings. See illustrations at right.

10.Attach electrode to burner.

11.Carefully replace burners.

12.Attach burners to brackets on firebox.

13.Reposition carryover tubes and attach to burners. Replace flame tamers and cooking grates.

Correct

burner-to-valve

engagement

Storing Your Grill

• Clean cooking grates.

• Store in dry location.

• When LP cylinder is connected to grill, store outdoors in a well-

ventilated space and out of reach of children.

• Cover grill if stored outdoors. Choose from a variety of grill

covers offered by manufacturer.

• Store grill indoors ONLY if LP cylinder is turned off and

disconnected, removed from grill and stored outdoors.

 

 

x

 

 

 

bo

 

 

e

 

r

 

 

Fi

 

 

 

 

 

 

e

 

 

 

b

 

 

 

tu

 

 

over

 

 

 

y

 

 

 

arr

 

 

 

C

 

Firebox

• When removing grill from storage, follow “Cleaning the Burner

Assembly” instructions before starting grill.

burner bracket

Electrode

463460708 • 9

Image 9
Contents Model 463460708 Product Guide Installation Safety Precautions Call Grill Service Center for Help and PartsSafety Symbols For residential use only. Do not use for commercialTable of Contents LP Liquefied Petroleum Gas LP Cylinder FillingOnly LP tanks equipped with this type of valve For your safety Connecting Regulator to the LP CylinderUseDo not household cleaning agents. Damage to gas LP Cylinder ExchangeLeak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Main Burner Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lightingSideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame CheckStoring Your Grill Cleaning the Burner AssemblyTurn gas off at control knobs and LP cylinder Very Important Burner tubes must reengage valveHow To Tell If Meat Is Grilled Thoroughly Food SafetyIndirect Cooking Indirect Cooking InstructionsStubborn Stains and Rust Routine CareKey Description KeyDescription Parts Diagram Model No Rear #8-32 Flange Nut #8-32x3/8 Screw Flange nuts Sharp EDGES! Wear gloves if necessary Sideburner valve bracket Control knob bezel Burner tube Place cooking grates into grill bottom Grease Cup Wire AA Battery Emergencies Possible Cause Prevention/Solution TroubleshootingElectronic Ignition Section Troubleshooting Electronic IgnitionLimited Warranty Please register your product online at Thank You for Your Purchase Grilling Safety Checklist