WARNING
Turn controls and gas source or tank OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Do not lean over grill while lighting.
1.Turn OFF all gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.Push in and turn the
5.Place match into match holder (hanging from side panel of grill). Light match; then light burner by placing match through the match light hole on right or left side of grill.
6.Push in and turn far right or far left burner knob to the HI position, depending on match light hole selected. Be sure burner lights and stays lit.
7.Light adjacent burners in sequence by pushing knobs in and turning to the HI position.
Sideburner Ignitor Lighting
Do not lean over grill while lighting.
1.Open sideburner lid. Turn ON gas at LP cylinder.
2.Push in and turn the
IGNITOR button.
4.If sideburner does NOT light, turn knob to OFF, wait 5 minutes, then repeat lighting procedure.
Sideburner Match Lighting
Do not lean over grill while lighting.
1.Open sideburner lid. Turn ON gas at LP cylinder.
2.Push in and turn the
3.Place lit match near burner.
4.Turn sideburner knob to HI. Be sure burner lights and stays lit.
Burner Flame Check
•Remove cooking grates and flame tamers. Light burners, rotate knobs from HI to LOW. You should see a smaller flame in LOW position than seen on HI. Perform burner flame check on sideburner, also. Always check flame prior to each use. If only low flame is seen refer to "Sudden drop or low flame" in the Troubleshooting Section.
HI
LOW
Turning the Grill OFF with AUTO-CLEAN™
With the Autoclean feature you have two choices for turning off your grill; Manual and
Manual Method
•Turn all knobs, including the
•Turn OFF the LP cylinder by turning the handwheel clockwise to a full stop.
NOTE: Always follow the lighting instructions found in the instruction manual and also located on the inside of the cabinet door prior to using the
AUTO-CLEAN™ Method
•After cooking is complete, set all main burner grill knobs to the high setting and close the grill lid.
•Push in and turn the
•Once at the clean position, release the knob and the green light should begin blinking.
•The valve will now stay on for 15 minutes before turning off the gas to the burners.
•After the clean cycle is complete, turn all knobs including the
•Turn OFF the LP cylinder by turning the handwheel clockwise to a
full stop.
For safety in storing a grill, the LP cylinder should always be turned
OFF.
If red light comes on while green light is flashing, the batteries will need to be replaced very soon.
When changing the batteries, please replace both batteries at the same time. Always replace with new batteries of the same type.
Ignitor Check
•Turn gas off at LP cylinder. Press and hold electronic ignitor button. "Click" should be heard and spark seen each time between each collector box or burner and electrode. See "Troubleshooting" if no click or spark.
Valve Check
•Important: Make sure gas is off at LP cylinder before checking valves. Knobs lock in OFF position. To check valves, first push in knobs and release, knobs should spring back. If knobs do not spring back, replace valve assembly before using grill. Turn knobs to LOW position then turn back to OFF position. Valves should turn smoothly.
Hose Check
•Before each use, check to see if hoses are cut or worn. Replace damaged hoses before using grill. Use only valve/hose/regulator specified by manufacturer.
8