Char-Broil 463270311 manual Holes on fascia to Attach valve bracket

Page 21

8

First, remove the two screws and lock washers factory attached to the sideburner valve bracket. Position sideburner valve bracket beneath sideburner shelf fascia so that valve stem comes through larger center hole in fascia. Align the holes on valve bracket with left and right holes on fascia. Secure using lock washers and screws that were removed from bracket.

Next, place sideburner bezel over valve stem on front side of fascia. Align small holes on bezel with upper and lower holes on fascia. Attach using two #8-32x3/8”screws and 4mm lock washers. Press sideburner control knob onto valve stem.

Note: Use left and right

holes on fascia to

attach valve bracket

Screws and Washers removed from valve bracket

Install bezel with “OFF” at top.

Sideburner fascia

Sideburner valve bracket

Note: Use upper and lower

holes on fascia to

attach bezel

Control knob

#8-32x3/8” screw

4mm

lock washer

Control knob bezel

Valve stem

9	Insert sideburner burner into left shelf.The stud on bottom of burner fits into rear small hole in sideburner drip pan on
	shelf, shown A. Secure burner to sideburner drip pan with one Wing nut, shown B. Make sure burner tube

engages sideburner valve, shown C.

B

Sideburner burner

A

Sideburner drip pan

Wing nut

C

Sideburner drip pan

Burner tube

21

Image 21

Contents Date Purchased Estimated assembly time 30 minutesThis Grill is for Outdoor USE only Table of ContentsCalifornia Proposition Installation Safety PrecautionsGrilling Guide Getting Started TemperatureFirst Time Use Lava Rock / BriquettesGrilling Guide Grilling Food SafetyDirect Cooking Indirect CookingGrilling Guide Tips & Tricks Usda Recommended Safe Minimum Internal TemperaturesGrilling Guide Cleaning Your Grill USE and Care LP Liquefied Petroleum GasLP Cylinder Filling For your safety UseDo not household cleaning agents. Damage to gasLP Cylinder Leak Test Leak Testing Valves, Hose and Regulator Connection, do not use this regulatorTurn all grill control knobs to OFF Ignitor Lighting For Safe Use of Your Grill and to Avoid Serious InjurySDo not lean over grill while lighting Open lid during lightingSideburner Ignitor Lighting General Grill CleaningSideburner Match Lighting Burner Flame CheckStoring Your Grill Cleaning the Burner AssemblyVery Important Burner tubes must reengage valve Turn gas OFF at control knobs and LP cylinderAll Parts Year from date of purchase Limited WarrantyKey Qty Description Parts ListParts Diagram Front Assembly Grill head Regulator hose Upper back panel Now you may fully tighten lower screws on upper back panel Holes on fascia to Attach valve bracket Electrode Self-tapping screw Wire Cylinder screw at rear of cart Grease tray Emergencies Possible Cause Prevention/Solution TroubleshootingAUTO-CLEAN Section Troubleshooting Electronic IgnitionPage Warranty Registration Department Box Columbus, GA