Grill Final Assembly, Part | Char-Broil 11601558 specs

8 ASSEMBLY GUIDE

GRILL FINAL Assembly

		Part	Qty.
C6	–	Battery	1
C7	–	Electronic Ignition Module	1
C8	–	Lid Handle	1

10-24x3/8"

screw	Fiber Washer
(qty 2)	(qty 2)

NOTE: The Ignition wiring shown below will only fit into the module one way. Be sure the wires are routed away from the heat source. Do not allow the wires to rest against hot areas of the grill.

Step 3 - Install the Electronic Ignition Module, Unscrew the Battery Cap and module nut from the module. Insert the module into the module bracket. Secure with the module nut. Install the Battery (C6) in the Electronic Ignition Module (C7) with the negative end first. Screw the Battery Cap back into place. Install the ignition wires as shown below.

Battery

	C6
+	-
	-
Battery	C7
Cap	Module
	Module
	Nut

Ignitor

Electrode

Ignitor Wire to

Ignitor Electrode

Ignition Wires from

Control Panel

Rear of Ignition

Module shown

Step 4 - Install the Lid Handle (C8) with 2 10-24x3/8" screws and 2 fiber washers as shown. Install the propane cylinder. Be sure to loosen the tank retaining bolt far enough to allow the cylinder to rest securely on the cart base. Tighten the tank retaining bolt and attach the propane regulator (not shown) when you are ready to use the grill.

	C8
	10-24x3/8"
Fiber	Screws
Washer	(2 each)
(2 each)

Cylinder valve facing RH side of grill.

20lb.Propane

Cylinder

Loosen Tank Retaining Bolt,install cylinder, then tighten.

Congratulations! You have successfully completed the assembly of your grill. Prior to using your grill, be sure to follow the

leak check instructions found in the Care and Use Guide.

Visit www.sizzleonthegrill.com/user-forumsto chat with Patio Bistro® owners just like you!