7 ASSEMBLY GUIDE | GRILL FINAL Assembly | |
|
|
|
PartQty.
C1 | – | Heat Tent | 1 |
C2 | – | Cooking Grate | 1 |
C3 | – Warming Rack | 1 | |
C4 | – | Control Knob | 1 |
C5 | – | Grease tray | 1 |
NOTE: The Cooking Grate may have sharp edges. Be very careful when handling the Cooking Grate. You should wear gloves when handling the Cooking Grate. The cooking grate ridges should run from front to back of the grill as shown below. Be sure that the cooking grate rests squarely on the brackets spaced around the lower body. This will make for easier grate cleaning as well.
Step 1 - With the Grill Lid open, place the legs of the Heat Tent (C1) into the matching impressions in the Lower Body. Next, Place the Cooking Grate (C2)into the Lower Body. The cooking grate ridges should run from front to back of the grill as shown below. Be sure that the cooking grate rests squarely on the three brackets spaced around the Lower Body.
C1
Ridges front to back
C2
Step 2 - Place the Warming Rack (C3) into position by first hooking the center pins into the windshield, then rotate the warming rack down into position. Next, Press the Control Knob (C4) onto the valve stem.
Install the Grease Tray (C5) by sliding the tray onto the Grease Tray Rails from the rear of the grill. Note: The grease tray rests between the grease tray rail stops. See detail shown in Figure A.
C3
Note: The control | Grease |
knob may be | Tray |
factory assembled | Rails |
| |
C4 | C5 |
|
Fig. A
Grease
Tray
Rail Stops
Visit