Lighting the Grill continued
Step 3
■Turn Righthand Burner Valve to “High.”
■Press Igniter Button to light. NOTE: If the flame doesn’t imme- diately light, turn off control knob and wait five minutes for gas to clear.
■Repeat steps 1 through 3.
■If the burner does not light on second try, turn off knob and try
■Repeat steps 2 and 3 for Lefthand L.P. gas cylinder and Lefthand Burner.
NOTE: You must push Igniter Button to ignite the second side of the grill.
■ All Burner Valves can be adjusted from “Low” to “High.”
Match Lighting
■Use a LONG wooden match or the match extension provided. Make sure all burner controls are off except one being lighted.
■Insert a match in the holder end of the extension, strike the match and place the match near the burner from above.
■Turn on BURNER CONTROL KNOB while holding match near burner.
■You must use another match to ignite the second side of the grill.
Tear Down/Clean
Step 1
■Make sure Burner Valves are in OFF position.
■Allow unit to cool completely.
Step 2
■Turn off fuel supply on both L.P. gas cylinders.
10
Tear Down/Clean continued
Step 3
■Remove Regulators from Propane Cylinder Connection.
Step 4
■Remove Grease Pans. Slide out from front of grill to clean or install new aluminum liners in Grease Pans.
Step 5
■Unlock tab as shown.
■Slide out Grease Tray.
■Clean thoroughly before storing grill.
■Slide Grease Tray back into position under grill and lock tab.