See b, Gas must be turned off at the supply tank

Connecting A Liquid Propane Gas (LP gas) Tank To Your Grill

1.Open the front Doors of cabinet. Pull out the

LPG Tank Pull-out Tray. Place a 20 Ib tank with foot ring into the hole in the tray, See

Fig.15a. Make sure the tank valve is in the OFF positon,

2.Align the tank so the Tank Valve faces the rear right corner of cabinet. Use the 5/ 16"x89mm Wing Bolt to secure gas tank from rear of tray.See Fig. 15a.

3.Check the tank valve to ensure it has proper external mating threads to fit the hose & regulator assembly provided (Type 1 connec- tion per ANSI Z21.58a-1998), See Fig.15b

4.Make sure all Burner knobs are in the OFF position.

5.Locate hose and regulator assembly packed for ship- pingpurposeson front underside of grillhead. Remove fastening band. Push assembly to back of grilland pull down to connect to tank valve. Before connecting, check valve and assembly threads to be sure they match. (Type 1 connection per ANSI Z21.58a-1998).

See Fig 15b

6.Inspect the valve connection port of the regulator

assembly. Look for damage or debris. Remove any debris. Inspect hose for damage. Never use damaged or plugged equipment.

7.Connect the hoseand regulatorassemblytothetank

valve (See Fig 14b) Hand tighten Quick Coupling Nut clockwise to a full stop. DO NOT use a wrench to tighten because it could damage the Quick Coupling Nut and result in a hazardous condition.

8.Open the tank valve fully (counterclockwise). Use a soapy water solution to check all connections for

leaks before attempting to light your grill. See "Check- ing for LP Gas Leaks" on page 17. If a leak is found, turn the tank valve off and do not use your grill until the leak is repaired.

Disconnecting A Liquid Propane Gas (LP gas) Tank From Your Grill

1.Turn the Burner Knobs and LP gas tank valve to the full OFF position. (Turn clockwise to close,)

2.Detach the hose and regulator assembly from the LP gas tank valve by turning the Quick Coupling Nut counterclockwise. See Fig.15b

CAUTION: When the appliance is not in use, the

gas must be turned off at the supply tank.

Figure 15a (LP gas model only)

FRONT

DOOR

TANK

TANK	PULL-OUT	J
		5/16"x89mm
TRAY
		WING BOLT

Figure 15b (LP gas model only)

GRILL HEAD

FRONT

DOOR

Type 1

per ANSI Z21.58a-1998

TRAY	/
	QUICK	ALREADY CONNECTED
	COUPLING	TO ADAPTOR UNDER
	NUT	SIDE BURNER