Grill Assembly | Electrolux 51 Stainless Steel Gas Grill manual

5Grill Assembly

IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling.

SIDE SHELF ATTACHMENT

1.Loosen the bolts on the side of the grill and attach the shelf by allowing the bolt heads to fall through the large opening in the bottom of the keyhole slots. Then slide the shelves downward until the bolts are resting against the top of the key hole slots. Tighten all of the shelf bolts. (See Fig. 1-2)

2.Attach the four (4) wires coming out from the left side of the grill to the igniter terminals. (See Fig. 3)

Note: It does not matter which wire goes to which terminal on the electronic igniter

INTERIOR PARTS INSTALLATION

1.Install the bottom flavor grids in the lower cutouts and around the igniters. (See Fig. 4)

2.Insert the top row of flavor grids with the 90 degree angled heat shield (bottom side of flavor grid) facing the rear of the unit into cutouts with tri- angle ridges facing up. (See Fig. 5-6)

Note: The right side of one flavor grid is extend- ed. This goes on the far right main burner, next to the bottom infrared burner.

3.Install cooking grates on the ledges provided on the grill to create your cooking surface. (See. Fig. 7)

4.Place warming shelf on support brackets by set- ting it flat across brackets allowing the two holes to line up with the holes on each bracket. (See

Faces the back of

the grill

Fig. 6
Fig. 6	in between burners
	Bottom flavor grids

		Fig. 7
	Cooking Grates	Fig. 7
	Cooking Grates

Warming Shelf

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5