Installation procedure

▪The worktop must be completely level.

▪Protect the cut-out surfaces.

▪Screw on the support elements provided using the respective screws on the front and rear end of the cooker hob (already configured with the relative holes and slots).

▪Connect the cooker hob to the mains electricity (consult the connection instructions).

▪Position the cooker hob in the cut-out.

▪Press it forcefully agianst the worktop.

Applying the sealant

The picture indicates how the sealant must be applied along the entire edge.

CONNECTION TO THE MAINS ELECTRICITY

▪The electrical connections must be carried out by qualified personnel only. The electrical connection must be protected in accordance with the regulations in force.

▪The connectors are accessible when the wires cover is opened.

▪Prior to connecting the appliance, verify that the voltage indicated on the rating plate complies with the mains voltage.

▪The rating plate of the glass-ceramic hob is located on the underside.

▪The appliance operates at 220-240V AC ~ (or, alternatively, at 380-415 V 2N~).

▪In the direct connection to the mains electricity, an omnipolar switch with a contact gap of 3 mm - suitably sized for the load and conforming to the regulations in force - is positioned between the appliance and the power outlet.

▪The type of electrical connection must be chosen according to the available installation options for the electric current and overload safety switches.

▪To ensure protection against fire, appliances of this kind can be installed between a taller cabinet on one side and a cabinet of equal height (as the appliance) on the other side.

▪For safety reasons, electrical connection components and insulated parts must not be accessible.

▪If the model is not equipped with a plug, mount a standardised plug on the power cord capable of withstanding the load indicated on the rating plate. The earth wire is identified by the yellow/green jacket. The plug must always be accessible.

Basic configuration of the sensors to the environment

(for model "7316-000" only)

After each connection to the mains electricity, basic configuration of the sensors must be carried out to ensure their optimal operation. All the displays turn on for a few seconds. There must be no objects on the hob surface during sensor configuration. Otherwise, the configuration