2.2Installing or Updating the MegaRAID Driver in an Existing Windows System
Perform the following steps to install or update the MegaRAID device driver in an existing Windows system:
Step 1. Boot the Windows operating system.
The Found New Hardware Wizard starts.
Step 2. Click the Next button and insert the driver diskette into the A:\ drive.
Step 3. Click the Search for a Suitable Driver... button, and click Next.
Step 4. Click the Next button.
In some cases, a message displays saying that this driver is not digitally signed. This message informs you that a nonsigned driver is being installed. If this message displays, click Continue Anyway.
Step 5. Select Floppy only, and then click the Next button in the Driver Files Search Results window.
Step 6. Click the Finish button to complete the driver installation, then repeat this process for all the adapters on your system.
2.3Installing the Windows System Driver in a New Windows System
Perform the following steps to install the MegaRAID device driver in a new Windows system. Windows automatically adds the driver to the registry and copies the driver to the appropriate directory.
Step 1. Start the Windows installation by booting from the Windows
The system BIOS must support booting from a
Installing or Updating the MegaRAID Driver in an Existing Windows System
Copyright © 2006 by LSI Logic Corporation. All rights reserved.