Chapter 4
SuSE Linux Enterprise
Server (SLES) 9 Driver
Installation
This chapter describes how to install the SuSE Linux Enterprise Server (SLES) 9.0 driver in the
•Section 4.1, “Installing the Driver in a New SuSE SLES Linux System”
•Section 4.2, “Updating the SuSE SLES 9 Driver”
4.1Installing the Driver in a New SuSE SLES Linux System
Note: If you use Service Pack (SP) 1 or SP 2, you need to load the driver. If you use SP 3 RC 2, the MegaSAS driver is already on the CD.
Perform the following steps to install the MegaRAID device driver in a new SuSE SLES Linux system:
Step 1. Boot the server with the SLES SP
The system BIOS must support booting from a
Step 2. At the installation message, press F6, then select
Installation and press ENTER.
Note: Follow screen instructions to switch between operating system CDs and operating system CD service packs.
Step 3. Put the driver update diskette in the drive bay, and install normally.
MegaRAID SAS Device Driver Installation User’s Guide |
Copyright © 2006 by LSI Logic Corporation. All rights reserved.