Outdoor LP Gas Barbecue Grill Model No. NPG2301-C
Assembly Instructions
DO NOT RETURN PRODUCT TO STORE.
For assistance call 1.800.762.1142 toll free.. Please have your owner’s manual and serial number available for reference..
For Easiest Assembly:
•To avoid losing any small components or hardware, assemble your product on a hard level surface that does not have cracks or openings..
•Clear an area large enough to layout all components and hardware..
•When applicable, tighten all hardware connections by hand first.. Once the step is completed, go back and fully tighten all hardware..
•Follow all steps in order to properly assemble your product..
Step Unfold legs
1 Unfold legs by pulling ring out and swinging leg out until it locks in place..
Step Attach side handles
2 A.. Attach handle, ignitor and heat plate support to right side of bowl using 2 sets of small washers (C), small lock washers (F), wing nuts (B) and 1 heat resistant washers (E)..
B.. Attach handle to left side of bowl using 2 sets of small washers (C), small lock washers (F) and wing nuts (B)..
Step
3
Step
4
Attach heat shield, burner, regulator and ignitor wire
A..Feed ignitor wire through opening in bowl..
B..Attach heat shield and burner to bowl with large washer (D), large lock washer (G) and wing bolt (A)..
C..Screw regulator clockwise onto burner stem..
D..Pull ignitor wire into ignitor..
WARNING: To avoid electrical shock, inspect before each use to make sure the igniter and wire are fully connected.
Attach lid handle
Attach handle to lid using 2 sets of small washers (C), small lock washers (F) and wing nuts (B)..