Broilmaster T3CFN, T3CAN owner manual Installing Char-Master Briquets

GRILL ASSEMBLY

8.Re-attach the ignitor to the control panel , then tighten nut and insert AA battery, positive side down, and re- place ignitor button. See Figure 9.

Figure 9

9.Install foam grip (4) on lid handle (3). See Figure 10. Tip: For ease of installation, slightly lubricate the lid handle with liquid soap before pushing the foam grip into place.

13.T3CA models only: Position Smoker Shutter (26) see the DPA100 instruction manual included with the T3CA

grills. See Figure 12.

14Set the cooking grids (6). See Figure 12.

15.Push valve knobs (22) on to valves.

Installing Char-Master Briquets

Individually place the ‘Char-Master’briquets in a single layer evenly on your grill’s briquet rack; DO NOT dump them onto the briquet rack. A single layer of ‘Char-Master’ briquets is all that’s needed. DO NOT overlap or stack the briquets.

See Figure 12.

After properly placing the ‘Char-Master’ briquets on your grill’s briquet rack, there may be some briquets left over. Save them for future use.

Before cooking, always preheat the grill as directed by the grill’s operating instructions. Hot briquets cause better, quicker cooking and better flavor.

Cleaning

Routine preheating and routine burn-off (also called post heating) of a grill will clean the ‘Char-Master’ briquets. Pe- riodically turn the briquets over while they are cool.

Figure 10

10.Fasten the lid handle to the grill body top (1) with two #10-24 x 1" screws. See Figure 11.

Figure 11

11.Place the briquet rack (7) or flavor screen (9) over the burners. See Figure 12.

12.T3 and T3C models only: Position the Char-Master bri- quets evenly on the briquette rack without overlapping. See Figure 12.

T3 & T3C MODELS T3CF MODELS

Figure 12

B101179-0-0907 Page 11