Broilmaster P4XFN-1, R3-1 manual Operation Propane & Natural GAS Grills, Checking for Gas Leaks

Page 31

OPERATION - PROPANE & NATURAL GAS GRILLS

Checking for Gas Leaks

Check for gas leaks every time you connect your Broilmaster® pro- pane gas grill to a Propane gas cylinder, when a connected cylinder has not been used recently, or when either a natural or propane grill is being used for the first time.

Caution: Do not use an open flame when checking for leaks. Checking for leaks with an open flame may lead to a fire or explosion, resulting in property damage or personal injury.

To check for gas leaks:

1.Use dish washing liquid and a little water to make a soapy solu- tion.

2.Turn OFF the knob on the control panel.

3.Turn ON the gas at the supply or cylinder. A hissing sound indicates a leak. Turn OFF the gas and repair the leak.

4.Apply the soapy water solution to all gas connections.

5.Look for bubbles. Bubbles indicate a leak.

6.If there are bubbles turn OFF the gas and repair the leak.

7.Turn the gas back ON and repeat the above procedures until all leaks are repaired.

Air Shutter Adjustment

The venturi air shutter(s) are preset at the factory so that after five minutes the burner flames are blue with well defined cones. If, after five minutes the flame is yellow, or there is a gap between the burner and the flame, adjust the venturi air shutter as follows:

1.Turn gas OFF and let the burner cool.

2.Loosen shutter set screw

3.Close the air shutter to the minimum opening.

4.Light the burner, wait five minutes and then carefully open the air shutter until the flame is blue and well defined.

5.Retighten the set screw.

Operating Instructions

Using the Ignitor

Caution: If a burner fails to light after 5 seconds, turn the burner OFF for 5 minutes, to allow the gas to clear, then try again.

1.Turn knob on the grill CLOCKWISE to the OFF position.

2.Turn ON gas at the source.

3.With the grill lid open, push and turn the burner control knob COUNTERCLOCKWISE to Hi.

4.Push and hold the ignitor button until the burner lights (approxi- mately 5 seconds).

5.If a burner does not light, turn OFF all gas and refer to the Troubleshooting section of this manual.

Operating Instructions

Using Matches

Caution: If a burner fails to light after 5 seconds, turn the burner OFF for 5 minutes, to allow the gas to clear, then try again.

1.Turn knob on the grill CLOCKWISE to the OFF position.

2.Turn ON gas at the source.

3.Open the grill lid.

4.Insert a burning long wooden match through the lighter hole on either side of the grill. See Figure 21.

5.Turn the burner control knob COUNTERCLOCKWISE to HI.

6.If a burner does not light, turn OFF all gas and refer to the Troubleshooting section of this manual.

Figure 22

B101623-5-1012

Page 31

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Models If YOU Smell GAS Empire Comfort Systems, Inc CongratulationsTable of Contents Master Parts Distributor List HOW to Order Repair PartsParts Not Under Warranty Warranty PartsP3X Series Parts Diagram P3SX P3SXN P3X P3XN P3XF P3XFN Index Part Description Part NumberP4X Series Parts Diagram P4XN P4XF P4XFN P4X Series Parts ListH3X Series Parts Diagram Index No Part Description Part Number H3X Series Parts ListH3X H3XN H4X Series Parts Diagram H4X H4XN H4X Series Parts ListR3 Series Parts Diagram Index Description Part Number R3 Series Parts ListR3N R3B R3BN Recommended Tools Grill AssemblyWarranty Terms Before You BeginWarranty Terms Grill Location Propane GAS GrillsCylinder Requirements See Figure Propane Cylinder SafetyCylinder Storage Connection RequirementsConnecting to Propane Gas / Cylinder Retention Means Pressure Regulator and Hose AssemblyClockwise Gas Type Natural GAS GrillsH4XN-1 Phillips Truss Head Screw 1/4-20 X 1 1/2 Hardware PackPhillips Truss Head Screw 10-24 X 3/4 HEX NUT, Lock Phillips Truss Head Screw 10-24 XInstalling Control Panel Shield Installing the Hose and Regula- torInstalling Control Panel See Figures 8 Ignitor AssemblyInstalling the Ignitor Installing Control KnobsWind Deflector Series Burner Shown Installing the BurnerSeries Shown Handle Lid Stop Installing Flare BustersP3X P4X Cleaning Installing RacksSee b Operating Instructions Air Shutter AdjustmentOperation Propane & Natural GAS Grills Checking for Gas LeaksPreheating Electrical AccessoriesOperation Before CookingBurn Off MaintenanceProblem Cause Solution TroubleshootingR3-1, R3N-1 ,R3B-1, R3BN-1 R3 only R3B onlyR3B only Description Part Number Quantit Supplied Safety Practices to Avoid Personal Injury Safety PrecautionsOutdoor USE only Grill Assembly Grill Assembly Grill Assembly Lid stop assembly hardware GAS Conversion to Natural GAS GAS Conversion to Natural GAS General Overview Infrared CookingSteak 1 Thick Infrared Cooking Sample Times & Grid PositionsCooking Grid Position Using the Ignitor Air Shutter Adjustment For R3B Series OnlyAvoid Water DAM AGE to Burner Clean burner venturi tubes as follows Blue Flame Burner MaintenanceGeneral Overview Infrared Burner MaintenanceBurn Off Standard CleaningProblem Cause Solution Appliance Service History Appliance Service History Appliance Service History Broilmaster
Related manuals
Manual 32 pages 17.57 Kb

P4XFN-1, R3-1 specifications

Broilmaster has been a trusted name in outdoor cooking, and their R3 series of gas grills, which includes models R3N-1, R3-1, R3BN-1, and R3B-1, exemplifies quality, performance, and innovation. Each model is thoughtfully designed to meet the demands of the modern grill master while ensuring a user-friendly experience.

One of the standout features of the Broilmaster R3 series is its powerful cooking system. All models are equipped with a high-performance stainless steel burner, providing even heat distribution and efficient cooking. This ensures that your food is cooked to perfection, whether it's a juicy steak, flavorful chicken, or grilled vegetables. The burners are designed to reach high temperatures quickly, allowing for searing and rapid cooking, which is essential for achieving that perfect char.

The R3N-1, R3-1, R3BN-1, and R3B-1 models feature an innovative cooking grid construction made from cast iron, which retains heat exceptionally well and provides excellent grill marks on your food. The cast iron grids, combined with the burners, create an optimal cooking environment that can accommodate various cooking styles, from direct grilling to indirect cooking.

Another significant characteristic of these grills is their durability. Constructed from heavy-duty materials, including rust-resistant stainless steel, the R3 series is built to withstand the elements, ensuring longevity and consistent performance. The grills come with a stylish and functional hood that not only enhances their aesthetic appeal but also helps retain heat effectively during the cooking process.

For added convenience, the R3 models feature an integrated ignition system that ensures reliable startup every time you fire up the grill. Many of the models also come with built-in side shelves, providing additional workspace for food preparation and storage of grilling tools. The added versatility of these grills allows users to explore a variety of cooking methods, including smoking and baking when equipped with optional accessories.

In summary, the Broilmaster R3N-1, R3-1, R3BN-1, and R3B-1 gas grills are excellent options for anyone looking to elevate their outdoor cooking experience. With their powerful burners, durable construction, and user-friendly features, they cater to both novice grillers and seasoned barbecue enthusiasts alike. The R3 series not only embodies excellent performance but also offers the versatility and reliability necessary for any grilling occasion.
Top Page Image Contents